Menyanthes User Manual - KWR Watercycle Research Institute

5.2.3 Units 185.2.4 Observation of level or summed flux 185.2.5 Check on the validity of imported data 195.3 Editing groundwater level series 195.4 Editing technical data of wells 205.5 Exporting data, results and graphs 215.5.1 Data, results 215.5.2 Graphs and figures 226 Groundwater statistics 236.1 The statistics window 236.2 Calculation of groundwater statistics 247 Creating a time-series model 267.1 Model identification 267.1.1 Options in the Groundwater Level Series frame 277.1.2 Options in the Explanatory Series frame 277.1.3 Adding explanatory series 277.2 Initial condition and start-up period 287.3 Parameter estimation 297.4 Evaluation of the results 308 Simulating groundwater level series 338.1 Running a simulation 338.2 Further interpretation of groundwater levels: Vegetation Reference Module 348.3 Further interpretation of groundwater levels: OGOR report 358.4 Further interpretation of groundwater levels: Spatial Analysis 359 Diver data view 379.1 About the Diver and Data management Tool 379.2 Walk through of Diver and Data management tool (step by step)Release history ofMenyanthes 379.2.1 Introduction 379.2.2 Barometric compensaton 379.2.3 Importing groundwater data 389.2.3.1 Method A – starting from existing technical data 389.2.3.2 Method B – starting from diver files 389.2.3.3 Checking imported series 399.2.3.4 Correcting and validating series 399.3 Various windows and functions of the Diver and Data management toolbox 399.3.1 The Diver Data View window 399.3.2 Buttons underneath the ‘Diver and hand measurements’ section 409.3.2.1 Importing diver files 419.3.2.2 Viewing and transferring series 419.3.2.3 Editing datalogger data series 439.3.2.4 Inputting or editing manual measurements 459.3.2.5 Validating data series 459.3.3 Technical data and the serial number of the datalogger 45Menyanthes Manual© KWR - 2 -