Acta Technica Corviniensis

More documents

Recommendations

Info

ACTA TECHNICA CORVINIENSIS – BULLETIN of ENGINEERINGACTA TECHNICA CORVINIENSIS– BULLETIN of ENGINEERINGcopyright ©UNIVERSITY POLITEHNICA TIMISOARAFACULTY OF ENGINEERING HUNEDOARA5, REVOLUTIEI331128 – HUNEDOARAROMANIAhttp://acta.fih.upt.ro642008/ACTA TECHNICA CORVINIENSIS/Tome I
1.VERONICA ARGESANU, 2. MIHAELA JULA, 3. IOAN LAZATHERMO ELASTIC INSTABILITYWITHIN A CLASS IV FRICITON JOINTAbstract:With a class IV couple of friction joint there are conditions when the disturbances of the pressures onthe interface increase, decrease or remain unchanged. When the two materials of the joint areidentical a relative stability is formed regarding this phenomenon, while a good heat-conductingmaterial coupled with a heat insulator, depending on certain characteristics of sliding speed, createsinstability.Materials of the same type making the joint tend to a relative stability when speaking of thisphenomenon, while a joint composed of a good heat conductor material and a insulator will alwaysshow characteristics of relative sliding speed, from which instability appears.Equation of this paper specifies the threshold for instability. The equations serve to provide the termsdepending on which the pressure disturbance in a frontal sealing interface increases. In this case loadconcentrations occur in small portions of the contact surfaces, resulting in damage or separation ofthe rings.Keywords:Thermo elastic instability; Solutions; Temperature waveINTRODUCTIONWith a class IV friction joint (annular joint),which is the primary sealing of a frontal sealing,may appear situations in which pressuredisturbances within the interface decrease,increase, or remain constant. These in turn areinfluenced by the properties of the materials incontact, coefficient of friction and relativesliding velocity.The increase of the pressure disturbances in theinterface leads to an increase in contact pressureand the local temperature. Adjacent to the zoneswith low pressure the surfaces can detachleading to important losses by leakage.Materials of the same type making the joint tendto a relative stability when speaking of thisphenomenon, while a joint composed of a goodheat conductor material and a insulator willalways show characteristics of relative slidingspeed, from which instability appears.The sliding contact at relatively high speeds isassociated with a macroscopic instability, so thaton a flat and uniform contact area will appeardisturbances of local pressure.This leads to negative effects upon the contactarea from the point of view of heating and wear.The simplified configuration of the primarysealing (class IV friction joint) is presented in Fig.1. For such geometry, if the pressure is uniform© copyright FACULTY of ENGINEERING – HUNEDOARA, ROMANIA 65
Page 2 and 3:
ACTA TECHNICA CORVINIENSIS- Bulleti
Page 4 and 5:
ACTA TECHNICA CORVINIENSIS - BULLET
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15: ACTA TECHNICA CORVINIENSIS - BULLET
show all

Acta Technica Corviniensis

Create successful ePaper yourself

Delete template?

Save as template?