Owner's Manual - Polaris
Owner's Manual - Polaris
Owner's Manual - Polaris
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MAINTENANCELightsHigh Beam AdjustmentThe headlight beam can be adjusted slightly upward or downward. Usethe following procedure to make the adjustment.1. Position the vehicle on a level surface with the headlight approximately25 ft. (7.6 m) from a wall. Place the transmission in PARK.25 ft. (7.6 m)Lamp Center Height2" (5 cm)2. Measure the distance from the floor to the center of the headlightand make a mark on the wall at the same height.3. Start the engine. Turn the headlight switch to high beam.4. Observe the headlight aim on the wall. The most intense part of theheadlight beam should be two inches (5 cm) below the mark on thewall. Include rider weight on the seat when measuring.5. The adjustment screw islocated on the right side ofthe headlight pod. To adjustthe beam, loosen the screw.Adjust the headlamp to thedesired position, thentighten the screw.AdjustmentScrew98