Owner's Manual - Polaris

FEATURES AND CONTROLSAll Wheel Drive SystemEngaging 4X4The 4X4 switch may be turned on or off while the vehicle is moving.Initially, the vehicle's electronic system will not enable 4X4 until theengine RPM is below 3100. Once enabled, 4X4 remains enabled untilthe 4X4 switch is turned off. If the switch is turned off while the demanddrive unit is moving, it will not disengage until the rear wheels regaintraction.Engage the 4X4 switch before getting into conditions where front wheeldrive may be needed. If the rear wheels are spinning, release the throttlebefore switching to 4X4.NOTICE: Switching to 4X4 or ADC 4X4 while the rear wheels are spinning maycause severe drive shaft and gearcase damage. Always switch to4X4 or ADC 4X4 while the rear wheels have traction or are at rest.Active Descent Control (ADC) SystemThe ADC system allows engine braking to all four wheels when thevehicle descends a hill or incline. Always move the 4X4 switch to ADC4X4 before ascending or descending a hill.Engaging Active Descent ControlThe ADC system will automatically engage when all four of the followingconditions occur:• The 4X4 switch must be in the ADC 4X4 position• Vehicle speed must be 15 mph (25 km/h) or less• The throttle must be closed (throttle lever released)• The transmission must be in gear (high, low or reverse)Disengaging Active Descent ControlThe ADC system will automatically disengage if at least one of the followingconditions occur:• The 4X4 switch is moved out of the ADC 4X4 position• Vehicle speed exceeds 15 mph (25 km/h)• The throttle is open (throttle is applied)• The transmission is shifted to neutral or park33