PA7300 Instruction Manual - TECO-Westinghouse Motor Company

1.2 DRIVE mode and PRGM mode displayed contentsPower onPRGM modePRGMDRIVE modeDRIVE *1DSPLAn- monitorsetDSPLBn- monitorsetDSPLFrequency referenceDSPLOutput Frequency*3*2When faultsOccurred beforepower supplywas turned offDSPLOutput CurrentSn- monitorsetDSPLCn- monitorsetDSPLHn- monitorset*1When the inverter is put into operation,the inverter system immediately enters intoPID detected value*4Display of faults whichoccurred before power supplywas turned offDSPLUn- monitorDSPLDRIVE mode. Press the PRGMDRIVEkey,An- monitorsetthe system will switch into PRGM mode.*2If the fault occurred before powersupply was turned off, the fault contentsare displayed when power ON.Fault occurrence order and display are∧∨provided by or key.Un fault : n =1~4,the fault occurrenceOrder, fault :the fault contents,please refer to page 111~114,the fault display.DSPLBn- monitorsetDSPLDSPLSn- monitorDSPLCn- monitor*3If no fault occurred before power supply was turned off , display the monitored dataaccording to the Bn-10 setting*4This block will be by passed if no fault occurred before power supply was turned off or a*5 RESETfault occurs and was reset byRESET*5When in the DRIVE mode, press the DSPL key andRESETkey, the setting values of SnandCn- will only be displayed for monitoring but not for changing or setting.36