PA7300 Instruction Manual - TECO-Westinghouse Motor Company

(1) Acceleration Time 1 (Bn-01)Acceleration time 1 is enabled when the accel/decel time change command of multi-functionterminal is "open", or the accel/decel time change function is not provided for themultifunction terminals. The acceleration time in which frequency reference goes from 0% to100% is set in the units of 0.1 second.(2) Deceleration Time 1 (Bn-02)Deceleration time 1 is enabled when the accel/decel time change command of multi-functionterminals is "open", or the accel/decel time change function is not provided for themultifunction terminals. The deceleration time in which frequency reference goes from 100%to 0% is set in the units of 0.1 second.(3) Acceleration Time 2 (Bn-03)Acceleration time 2 is enabled when the accelldecel time change command of multi-functionterminals is "closed". The acceleration time in which frequency reference goes from 0% to100% is set in the units of 0.1 second.(4) Deceleration Time 2 (Bn-04)Deceleration time 2 is enabled when the accel/decel time change command of multi-functionterminals is "closed". The deceleration time in which frequency reference goes form 100% to0% is set in the units of 0.1 second.(5) Frequency Reference Gain (Bn-05)The input level when frequency reference voltage is 10V is set in the units of 0.1%.Examples are shown in the below.(6) Frequency Reference Bias (Bn-06)The input level when frequency reference voltage is 0V is set in the units of 0.1%.ExampleINPUT LEVEL% Bn-06 is positive value. Bn-05 = 50.0Bn-05 a: Bn-06 = 10.050%Bn-06 isb: Bn-06 = -10.010Bn-06negative value.(a)0 FREQUENCY0V 10VREF.Bn-06(b) -10(7) Torque Compensation Gain (Bn-07)Torque compensation gain is set in the units of 0.1.(8) Multi-Function Analog Output A01 Bias(Bn-08)(9) Multi-Function Analog Output A02 Bias(Bn-09) The output voltage of Multi-function analog output A01 and A02 can be shifted upor down by Bn-08 and Bn-09 in the units of % individually.43