PA7300 Instruction Manual - TECO-Westinghouse Motor Company

SetValueFunction LCD display (English) Description0C to 0F Not used Reserved 10 UP command UP command Closed: Output frequency increment11 DOWN command DOWN command Closed: Output frequency decrement12 FJOG command Forward Jog13 RJOG command Reserved JogClosed: Forward jog runFWD LED lights. Display: 6HzClosed: Reverse jog runDigital operator REV LED does not light.Display: 6 Hz14 to 1F Not used Reserved 20 to 2F External fault 5 External fault 530 to 3F External fault 6 External fault 640 to 4F External fault 7 External fault 7External fault signal input50 to 5F External fault 8 External fault 860DC injection brakingcommand(JOG with priority)DC Brakin CommandClosed: DC injection braking applied when thefrequency output is less than the DCinjection start frequency and the DCinjection braking command is closed.61 Search 1 Max. Freq. Spd_Search Closed: Search from max frequency62 Search 2 Set Freq. Spd_Search Closed: Search from set frequency63~64 Not used Reserved 65 Integral value reset I_Time Reset Closed: Integral value reset at PID Control66 PID control cancel PID Invalid Closed: PID control canceled67 to FF Not used Reserved Setting error (OPE03) occurs by setting to Sn-15 to -18 in the following cases.When set values are not listed from the smaller to the larger.When more than two search references of set values 61, 62 and 64 are setsimultaneously.When the following combination is set at Sn-15 to -18, set value fault (OPE03) occurs.Set values are not in a descending order.More than two search commands of set values 61 and 62 are set.UP/DOWN commands are not set simultaneously (only one command can be set.)UP/DOWN and accel/decel prohibit commands are set simultaneouslyMore than two set values except FF are set.86