User Manual - TOSHIBA TEC store

2. PRINTER SETUP ENGLISH VERSION EO1-330582.4 Loading the Media2.4 Loading the Media(Cont.)12. There are four issue modes available on this printer. How to set themedia for each mode is provided below.Batch modeIn the batch mode, the media is continuously printed and fed until thenumber of labels/tags specified in the issue command have been printed.NOTES:1. Be sure to set the SelectionSwitch to STANDARD/PEEL OFF position.2. The backing paper is easierto feed back to the Take-UpSpool if the Front Plate isremoved.3. Fit the Take-Up Clip so thatthe longer side of the clip isfitted into the shallow groovein the Take-Up Spool.4. The backing paper can bewound directly onto the TakeupSpool or a paper core.When using the Take-upSpool, detach the HolderStopper by removing the B-3x4 screw. Otherwise, it maybe difficult to pull out thewound backing paper roll.Strip mode (Option)When the optional Strip Module is fitted, the backing paper isautomatically removed from the label at the Strip Plate as each label isprinted.(1) Remove enough labels from the leading edge of the media to leave500mm of backing paper free.(2) Insert the backing paper under the Strip Plate.(3) Wind the backing paper onto the Take-up Spool and fix it in positionwith the Take-up Clip. (Wind the paper counterclockwise aroundthe spool as this is the direction it rotates.)(4) Rotate the Take-up Spool anti-clockwise a few times to remove anyslack in the backing paper.(5) Set the Selection Switch mounted on the Rewinder Assembly toSTANDARD/PEEL OFF position.Take-up SpoolHolder StopperB-3x4 ScrewTake-up SpoolTake-up ClipWhen using a paper core, putthe core on the Take-up Spoolwith the Holder Stopper on it,and attach the top edge of thebacking paper to the corewith adhesive tape. TheTake-up Clip is notnecessary.This winding method isapplicable to the Built-inRewinder mode.Front PlateBlack ScrewStrip PlateBacking PaperTake-up ClipE2- 7