User Manual - TOSHIBA TEC store

2. PRINTER SETUP ENGLISH VERSION EO1-330582.9 Setting an Operating Environment2.9.1 Parameter Setting(Cont.)NOTES:1. It takes about 2 seconds toperform an Auto Print Headcheck.2. It is recommended that thisfunction should be activated whenhigh quality printing such as barcodes printing is required.Otherwise, choose OFF.3. When a broken element is found,the printer stops, displaying“HEAD ERROR”. The errorstate can be cleared by pressingthe [RESTART] key, but if thebroken element affects bar codereadability or actual operations,please replace the print head witha proper one.(18) Auto Print Head Check SelectionThis parameter is to choose whether to perform the Auto Print HeadCheck function at the power on time. When “PARAMETER SET”appears, press the [PAUSE] key until the following display appears.PARAMETER SETAUTO HD CHK OFFUse the [FEED] or [RESTART] key to select a desired option.[RESTART][FEED]AUTO HD CHK OFFAuto print head broken elementcheck is not performed.AUTO HD CHK ONAuto print head broken elementcheck is performed.After selecting auto print head check, press the [PAUSE] key.(19) Centronics Interface ACK/BUSY Timing SelectionThis parameter is to choose an ACK/BUSY timing of the Centronicsinterface.“TYPE1” has been chosen as default, but if a communication error occursor a communication is not properly made, change to “TYPE2”.When “PARAMETER SET” appears, press the [PAUSE] key untilthe following display appears”.PARAMETER SETACK/BUSY TYPE1Use the [FEED] or [RESTART] key to select a desired option.[RESTART][FEED]ACK/BUSY TYPE1A rise of ACK signal and a release ofBUSY occur at the same time.ACK/BUSY TYPE2A fall of ACK signal and a release ofBUSY occur at the same time.After selecting an ACK/BUSY timing, press the [PAUSE] key.E2-25