User Manual - TOSHIBA TEC store

2. PRINTER SETUP ENGLISH VERSION EO1-330582.9 Setting an Operating Environment2.9.1 Parameter Setting(Cont.)NOTE:Improper setting of the solenoid typemay disable the ribbon savingfunction.(11) Solenoid Type SelectionThis parameter is to choose the solenoid type that is actually installed.When “PARAMETER SET” appears, press the [PAUSE] key untilthe following display appears.PARAMETER SETSOLENOID TYPE1Use the [FEED] or [RESTART] key to select a desired option.[RESTART][FEED]SOLENOID TYPE1TDS-12C (Insulation tape is blue.)SOLENOIDTYPE2TDS-16A (Stronger pull force type)(Insulation tape is black.)After selecting the solenoid type, press the [PAUSE] key.NOTES:1. The ribbon saving function isavailable only when an optionalribbon saving module (B-9904-R2-QM-R) is installed.2. Ribbon saving option should beselected according to the headlever position. Incorrect settingmay disable the proper ribbonsaving function.3. The ribbon saving function isactivated when there is a 20-mmor more non-print area in themedia feed direction.4. Ribbon saving is enabled up to 4areas per media.(12) Ribbon Saving Function SelectionThis parameter is to choose whether to activate the Ribbon savingfunction or not.This function enables reducing the ribbon loss caused by taking upunused ribbon during non-print areas.When “PARAMETER SET” appears, press the [PAUSE] key untilthe following display appears.PARAMETER SETRBN SAVE ON (TAG)Use the [FEED] or [RESTART] key to select a desired option.[RESTART][FEED]RBN SAVE ON (TAG)Activated (When the head lever is set to“(2)TAG”.)RBN SAVE ON (LBL)Activated (When the head lever is set to“(1)LABEL”.)RBN SAVE OFFNot activatedAfter selecting the ribbon saving function, press the [PAUSE] key.E2-21