User Manual - TOSHIBA TEC store

This product is equipped with a wireless communication device,TEC-RFID-US1 (B-9704-RFID-U1-US-R)TEC-RFID-EU1 (B-9704-RFID-U1-EU-R)Please be sure to read the enclosed precaution for handling of wireless communication devices before using thisproduct.Precautions for Handling of Wireless Communication DevicesRFID kit: TEC-RFID-US1 (B-9704-RFID-U1-US-R)TEC-RFID-EU1 (B-9704-RFID-U1-EU-R)For all countries and areasThis product is a wireless communication device, and the use of this product is restricted to the following countries orareas. If the product is used in the countries or areas other than the following, you may be punished according to thelaws of those countries or areas.TEC-RFID-US1 (B-9704-RFID-U1-US-R): USA, CanadaTEC-RFID-EU1 (B-9704-RFID-U1-EU-R): Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland,France, Hungary, Germany, Greece, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland,Portugal, Slovakia, Slovenia, Spain, Sweden, United Kingdom, Norway, Liechtenstein, Iceland, SwitzerlandFor safetyDo not use the product in locations where the use is forbidden, for example in a hospital.When you do not know the forbidden areas, please refer to and follow the medical institution.Otherwise medical equipment may be affected, causing a serious accident.This product may affect the operation of some implanted cardiac pacemakers and other medically implantedequipment. Pace maker patients should be aware that the use of this product very close to a pacemaker might causethe device to malfunction.If you have any reason to suspect that interference is taking place, immediately turn off the product and contact yourTOSHIBA TEC sales agent.Do not disassemble, modify, or repair the product.Doing so may cause injury. Also, modification is against the Laws and Regulations for Radio Equipment. Please askyour TOSHIBA TEC sales agent for repair.For USAThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received , including interference that may cause undesired operation.Changes or modification not expressly approved by manufacturer for compliance could void the user’s authority tooperate the equipment.For CanadaOperation is subject to the following two conditions:(1) this device may not cause interference, and(2) this device must accept any interference , including interference that may cause undesired operation of the device.For EuropeHereby, Toshiba TEC Corporation, declares that this TEC-RFID-EU1 (B-9704-RFID-U1-EU-R) is in compliance withthe essential requirements and other relevant provisions of Directive 1999/5/EC.This equipment uses the radio frequency band which has not been harmonized throughout all EU and EFTA countries,and can be used in the following countries.Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Hungary, Germany, Greece, Ireland,Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, UnitedKingdom, Norway, Liechtenstein, Iceland, Switzerland