User Manual - TOSHIBA TEC store

2. PRINTER SETUP ENGLISH VERSION EO1-330582.9 Setting an Operating Environment2.9.1 Parameter Setting(Cont.)(26) Label End/Ribbon End SelectionThis parameter is to choose a printing process when a label end or ribbonend is detected.When “PARAMETER SET” appears, press the [PAUSE] key untilthe following display appears.PARAMETER SETLBL/RBN END TYP1Use the [FEED] or [RESTART] key to select a desired option.[RESTART][FEED]LBL/RBN END TYP1TYPE1: When a label/ribbon end isdetected in the middle of printing,printing is immediately paused.LBL/RBN END TYP2TYPE2: When a label/ribbon end is detectedin the middle of printing, the printer prints thehalf-finished label as far as possible, andstops when the next label is at the homeposition.After selecting a Label End/Ribbon End type, press the [PAUSE] key.(27) Pre-Strip SelectionThis parameter is to choose whether to activate the Pre-strip function.When this parameter is set to ON (Available), the top edge of a label isseparated (pre-stripped) from the backing paper before the label is printed.This function is intended to make the strip issue easier in case the labelsare hard to strip due to the label intensity, adhesive power, or the printingspeed.When “PARAMETER SET” appears, press the [PAUSE] key untilthe following display appears.PARAMETER SETPRE PEEL OFF OFFNOTE:When the print speed is set to10”/sec., the pre-strip function willbe activated regardless of thisparameter setting.Use the [FEED] or [RESTART] key to select a desired option.[RESTART] PRE PEEL OFF OFF Unavailable[FEED]PRE PEEL OFF ON AvailableAfter selecting the Pre-strip function, press the [PAUSE] key.E2-29