ICPAGING Application User Manual - Barix

2 Running ICMASTER2.1 Booting up PS16 ICMASTERPower up the PS16. If the SonicIP is enabled, you will hear the IP which the PS16 got from yourDHCP server. After that the device will start detecting the USB stick. The following message will beshown on the PS16 LCD while the check is being performed:Checking USB sanityWhen the check was successful, the ICMASTER idle message will be displayed:IcMaster, FDX1.02 04.07.2012,16 keysIn case of broken or missing USB stick, the application will display an error message, and will exit:Bad USB stick fsIn this case, please power off the PS16, remove the two screws from the bottom, open the cover,and replace the USB stick with a new one, formatted with FAT32 file system. Also, have in mindthe following important notes:NOTE 1: If you plan to use the ICMASTER on Annuncicom 100/200, please plug in a formattedUSB stick, otherwise the application will not start.NOTE 2: Depending on your configuration, the following files may be present on your USB stick:– UNATTSND – this is the recorded unattended mode message;– CUSTMSG – this is the recorded custom message;– TEST.USB – an empty temporary file created during USB stick check;– xxx.MP3 – station ID specific ring tone files, where xxx is the station ID (for example002.mp3 is the ring tone for station ID=2).None of them is required for the application to boot, but it is advised to backup these files(without the TEST.USB as it will be deleted and recreated during boot) and copy them tothe new USB stick to keep the same configuration.2.2 PS16 Keyboard LayoutThe PS16 Paging main unit has 16 functional buttons, a flexible microphone, speaker, and 2 lineLCD. Optional extensions with 48 keys can be attached on the right side of the PS16 main unit.Key layout for PS16, as well as for every master device, is shown in the web UI home page, as inIllustration 1:10 Running ICMASTER