1926-1984 Vintage Models - S&S Cycle

1926-1984 Vintage ModelsParts forTwin Cam 96 /103 2007-2012Complete KitManifold IncludedReplacement parts on page 5-97S&S® SUPER E & G CARBURETOR KITSSuper E CarbPartial KitManifold Not IncludedSuper G CarbComplete KitManifold IncludedModelsStandard Tanks Standard Tanks 5 Gallon Tanks § Standard TanksBig Twin Models1979-'84 11-041111-043111-04181966-'78 11-0402 11-041211-04221955-'65* 11-0401 – –Harley-Davidson® Ironhead Sportster® Models1979-'85 ‡ 11-0406 – – –1957-'78 ‡ 11-0404 – – 11-0424Carb OnlyAll Years 11-0420 – – 11-0421* Outside oil lines that feed heads on knucklehead and 1963-'65 panhead engines must be refabricated or use a 1" spacer block for additional clearance.‡ Does not fit engines equipped with vertical magneto.§ Shovelhead engines equipped with .075" longer than stock cylinders in chassis with five gallon gas tanks require additional air cleaner cover to gas tank clearance. Kits in this column include an aircleaner cover clearanced to fit these engines.NOTE: 1979-'80 engines may be equipped with either o-ring or band style heads. Check before ordering.PERFORMANCEPARTSParts forTwin Cam 88 ®1999-2006Parts forEvolution ®1984-1999Parts forSportster ® & Buell ®1986-2012Parts forVintage Engines1926-1984Parts forX-Wedge®2007-2012Parts forVictory®, Off-road& MetricRacingProductsNOTES:Stock motorcycles 1980 or earlier must be updated to a two cable pull open/pull closed throttle control system. A single cable pull open system cannot pull the throttle closed in casethe throttle should accidentally stick in the open position. S&S offers high quality throttle cable kits in several lengths for this purpose. A press-on sleeve is also available to increasethe diameter of the throttle grip area of 1972 and earlier handle bars to 1", allowing installation of modern throttle assemblies. See Section 7 for throttle cables and press-on sleeves.S&S "Shorty" carburetors will not fit Harley-Davidson® ironhead Sportster® models with vertical magnetos due to clearance problems between the magneto and the carburetor.Shovelhead engines with five gallon gas tanks and cylinders that are taller than stock require a special notched air cleaner cover to clear the gas tank. Since these taller engines also requirea special length manifold, select a carb with a notched air cleaner cover without a manifold from the chart and refer to the manifolds starting on page 4-22 to select the correct lengthmanifold.S&S does not recommend polishing or chrome plating Super E & G carburetors. Our repair department has seen many carbs with passages plugged with polishing compounds andsome carbs that had been destroyed because the polishing or chrome plating had altered critical machined surfaces.Recommended for racing only – S&S Super E & G carburetors shown in this catalog section are not legal for use on motor vehicles operated on public highways in the state of California,or in other states where similar pollution laws may apply. The user shall determine the suitability of the product for his or her use and shall assume all risk and liability in connectiontherewith.Tools & ShopSuppliesDealer Services& Promo ItemsWarranty &Company PolicyOEM Cross ReferenceAppendix & IndexVisit us at www.sscycle.com5-71