Emulation Command Set Reference Manual - Hengstler GmbH

XPM Emulation Command Set Reference2.2.23 Start block rotation ESC [F0] [0B] [01] [n][Name][Function]Start block rotation (Note: Advanced Firmware Set only)This command signifies that all commands sent after it are to be treated as a singleblock and rotated intact as specified below.[Code] [1B] 16 [F0] 16 [0B] 16 [01] 16 [n][Description][27] 10 [240] 10 [11] 10 [1] 10 [n]1. Command „ESC [F0] [0B] [01] [n]“ signifies that all commands and data sent after it, until receiptof the End Block Rotation command, are to be treated as a single block and rotated intact asspecified below.2. Parameter [n] defines the angle of rotation for the entire block:Parameter [n]Angle of rotation[FF] 16Disabled[00] 16 0°[01] 16 90°[02] 16 180°[03] 16 270°3. The upper left corner of the block is the key when rotating, and the block will start as far to theupper left as defined by the rotation of the objects sent.The “T” in “The” is theupper left hand cornerbefore rotation.The “T” in “The” is the upper left hand corner after rotation.4. Please note that all commands, including Line Feed, are stored and are used only to position andformat the data to be printed. Once this command has been sent, there will be no printing untilreceipt of the End Block Rotation command, which will cause the entire block to be printed.5. The commands “Print uncompressed graphics” and “Print RLE8 compressed graphics” areignored by the Start Block Rotation command.Part No. D 690 004 Page 36 of 112 Mod.Nr. 4 240512 HOR1