Emulation Command Set Reference Manual - Hengstler GmbH

More documents

Recommendations

Info

XPM Emulation Command Set Reference2.2.25 Printer reset (software) ESC ‘@’[Name]Printer reset (software)[Function] This command initializes/resets the printer.[Code] [1B] 16 [40] 16[27] 10 [64] 10[Description]1. Command „ESC ‘@’” resets the printer settings to their default values.2. “Default” is defined as the status of the printer after initial power up.3. Command „ESC ‘@’” prints the data contained in the print buffer before resetting.Part No. D 690 004 Page 38 of 112 Mod.Nr. 4 240512 HOR1
XPM Emulation Command Set Reference2.2.26 Printer reset (hardware) ESC [F2] [03] [00][Name]Printer reset (hardware)[Function] This command performs a hard reset of the printer by resetting the hardware.[Code] [1B] 16 [F2] 16 [03] 16 [00] 16[27] 10 [142] 10 [03] 10 [00] 10[Description]1. Command „ESC [F2] [03] [00]“ performs a hardware reset of the printer.2. When command „ESC [F2] [03] [00]“ is executed, the printer does not print the buffer beforeresetting. All data in the buffer is lost. All conditions are returned to those that would exist if thepower were removed and then restored.Part No. D 690 004 Page 39 of 112 Mod.Nr. 4 240512 HOR1
Page 8 and 9: XPM Emulation Command Set Reference
Page 88 and 89:
XPM Emulation Command Set Reference
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112:
show all

Emulation Command Set Reference Manual - Hengstler GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?