Emulation Command Set Reference Manual - Hengstler GmbH

More documents

Recommendations

Info

XPM Emulation Command Set Reference2.2.29 Bar code height setting GS ‘h’ [n][Name]Bar code height setting[Function] This command sets the height of a bar code in dots.[Code] [1D] 16 [68] 16 [n][29] 10 [104] 10 [n][Description]1. Command „GS ‘h’ [n]“ defines the height of a bar code.2. Parameter [n] specifies the height of the bar code in dots.3. The following conditions must be satisfied:[1] 10 ≤ [n] ≤ [255] 10 .4. The default value of parameter [n] is [60] 10 .Part No. D 690 004 Page 42 of 112 Mod.Nr. 4 240512 HOR1
XPM Emulation Command Set Reference2.2.30 Bar code width magnification setting GS w [n][Name]Bar code width magnification setting[Function] This command sets the width magnification for a bar code.[Code] [1D] 16 [77] 16 [n][29] 10 [109] 10 [n][Description]1. Command „GS w [n]“ specifies the width magnification of a one-dimensional bar code bymultiplying the dot width of the narrow and wide bars by a specified integer value.2. Parameter [n] specifies the horizontal magnification of a bar code.3. The following conditions must be satisfied:[1] 10 ≤ [n] ≤ [4] 10 .4. The default value of parameter [n] is [1] 10 .5. The widths of the narrow and wide bars (black and white) are multiplied by [n].6. This command is ignored two-dimensional bar codes.Part No. D 690 004 Page 43 of 112 Mod.Nr. 4 240512 HOR1
Page 8 and 9: XPM Emulation Command Set Reference
Page 92 and 93:
XPM Emulation Command Set Reference
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112:
show all

Emulation Command Set Reference Manual - Hengstler GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?