FILARC flux - Esab

FILARC flux- andmetal- coredwelding wiresFILARC PZ6113AWS A5.20-95 : E71T-1 H4E71T-1M H8EN 758-97 : T 42 2 P C 1 H5T 46 2 P M 1 H10Contents page 4Welding parametersPrevious pageNext pageDESCRIPTIONMulti-purpose, all-position rutile fluxcoredwire for use in CO 2 or Ar/CO 2gas, applied by shipyards all overEurope. This "welder friendly" wire withits soft, spatter-free arc, always operatesin the spray arc mode. It is possibleto weld in any position with onediameter and the same parameters(Ø1.2mm/230A), so ideal for fit-up work.Deposition rates in vertical-up weldingcan reach 4-5kg/h, making it one of themost productive consumables available.Because of spray arc operation, typicalpositional welding defects like lack offusion and slag inclusions are avoided.The wire has a high tolerance for poorjoint preparations. The slag is easilydetached. Good bead appearance withsmooth tie-in. One sided root runs aremade economically on ceramic backing.WELD METAL COMPOSITIONC : 0.04-0.08% P : ≤0.025%Si : 0.30-0.70% S : ≤0.025%Mn: 1.00-1.50%SHIELDING GASCO 2 and Ar/15-25%CO 2EN 439: C1, M21WELD METAL HYDROGENEuronorm 758-95: class H10/H5Typical values in Ar/20%CO 2: 5.0ml/100gin CO 2: 3.9ml/100gFor information on the influence of parameterson the hydrogen level, see page 22-25.APPROVALSsee pages13 to17for gradesABSBVCCSContr.CRSDBDNVFORCEGLLRMRSPRSRINATÜVUDTPOSITIONSDEPOSITION DATA IN: CO 2 or Ar/CO 2Diameter1.2mmStickout20mmI V wire Dep. rate[A] [m/min] [kg/h]150 5.8 2.1250 11.6 4.2350 20.7 7.5ALL WELD METAL MECHANICAL PROPERTIESDiameter1.4mmStickout20mmI V wire Dep. rate[A] [m/min] [kg/h]150 3.3 1.8250 6.6 3.6350 11.6 6.3Diameter1.6mmStickout20mmI V wire Dep. rate[A] [m/min] [kg/h]150 2.8 1.8250 5.0 3.3350 8.3 5.4450 12.4 8.1CURRENTANDPOLARITYDC +CO 2 Ar/15-25%CO 2Tensile strength, R m [MPa]: 510-590 550-640Yield strength, R e [MPa]: ≥420 ≥460Elongation, A 5 [%] : ≥22 ≥22Impact value, A v (ISO-V)– 20°C [J] : ≥54 ≥54CERAMICBACKING39