FILARC flux - Esab

FILARC flux- andmetal- coredwelding wiresFFILARC PZ6137EGAWS A5.26-91 : EG72T-Ni1Contents page 4Previous pageNext pageDESCRIPTIONWELD METAL COMPOSITIONFILARC PZ 6137EG is a high produc-C : 0.05-0.09% Mo: 0.10-0.20%DEPOSITION DATA IN: CO 2tivity basic flux-cored wire for electro-Si : 0.25-0.50% P : ≤0.025%gas welding, providing good impactMn: 1.10-1.50% S : ≤0.025%toughness down to –20°C. Good arcNi : 0.70-1.10%stability and smooth weld metal washcan be obtained in plate thicknessesfrom 10 to 35mm.SHIELDING GASUnlike traditional EG welding wires,welding speeds up to 10m/h can be CO 2applied in vertical-up and 45° slopeupEN 439: C1positions. The reduced heat inputresulting from higher welding speeds(especially Ø 1.6mm), provides very WELD METAL HYDROGENreliable mechanical properties; also inthe parent metal heat affected zone. Euronorm 758-95: class H5PZ 6137EG is designed for weldingmild and higher tensile steels such as Typical value in CO 2: 2.0ml/100gHI/HII, StE355 as well as A32-E36 in (valid for Ø1.6mm/300A/20mm stick-out)the vertical-up position.APPROVALSsee pages13 to17for gradesABSBVDNVGLLRMRSPRSTÜVUDTPOSITIONSDiameterStickout1.6mm25mmI V wire Dep. rate[A] [m/min] [kg/h]250 6.4 4.6350 11.9 8.5450 19.2 13.7ALL WELD METAL MECHANICAL PROPERTIESDiameter2.4mmStickout25mmI V wire Dep. rate[A] [m/min] [kg/h]350 4.1 5.4450 6.9 9.0550 10.0 13.2Tensile strength, R m [MPa]: 540-650Yield strength, R e[MPa]: ≥420Elongation, A 5 [%] : ≥22Impact value, A v (ISO-V) – 20°C [J] : ≥45–29°C [J] : ≥27CURRENTANDPOLARITYDC +DC –51