Quick Reference for End-Users CarboSen1000 Sensors ... - lamtec

6 Operation6 Operation6.1 Operation / Measurement Value Display6.1.1 Operation6.1.2 Measurement Value• via programming unit (optional)6.1.3 Status SignalsProbe voltage-100…+900 mV, transmission via analogue output 1 (0/4...20mA)ST-Tap version: Pin3 and Pin4 of circular plug.Electronic XC164-Tap: Terminal 4 and Terminal 5Other measurement values can be transmitted via an analogue output module (optional).Transmission via digital output module (optional)6.2 General Instructions for Operation6.2.1 Operational Failure, Switching On and Off6.2.2 Liquid PurificationWith a longer period of failure, from approximately 3 months onwards, we recommend themeasurement to be shut down. In order to avoid the probe sensor from being damaged, theprobe sensor must be dismantledWe recommend you to leave the measurement to run during periods of short failure.You are allowed to perform a wet cleaning of the boiler, when you dismantle the probe beforehand.If you perform a wet cleaning to an installed probe, this could lead to damaging of theprobe. An error free operation is then no longer possible.CAUTION!For the wet cleaning, the probe must be dismantled by all means. A wet cleaning of an installedprobe will lead to damaging of the probe.28