12.07.2015 Views

Allegro RED Owner's Manual - Tiffin Motorhomes

Allegro RED Owner's Manual - Tiffin Motorhomes

Allegro RED Owner's Manual - Tiffin Motorhomes

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

TIFFIN MOTORHOMES –ALLEGRO <strong>RED</strong>® Chapter 12 WINDOWS, AWNINGS, VENTS & DOORSTo close the awning:NOTE: Pinch Hazard. When closing awning, bottom arm will fold down and against back channel. This area must bekept clear of people and objects. Failure to heed this warning could cause severe personal injury and/or propertydamage.1. Remote Rocker SwitchA. Press and hold the “Retract” button to automatically close awning. If the button is released theawning will stop. Maintain button depressed until awning is fully retracted, then release.IMPORTANT: As an extra safety precaution, visually verify that the awning is fully closed. To adjust the awning pitch:NOTE: Pinch Hazard. When adjusting awning pitch, bottom arm will telescope. Keep hands and objects clear ofopenings around bottom arm. Failure to heed this warning could cause personal injury.1. With awning fully extended, loosen knob on bottom arm.2. Pull top arm down to lower roller tube to desired height.3. While holding top arm in place, tighten knob to set pitch.4. Repeat for hardware on other side.IMPORTANT: To ensure rain water will run off awning, ensure that one end of the awning is lowerthan the other end. This will reduce the potential for water pooling in the center of the awning.5. Prior to closing awning, loosen knob to allow awning to reset to original position. Lightly tighten knobto reduce potential for sounds of rattling during travel.In case of awning power failure or to manually close awning:IMPORTANT: This procedure will require two people. When this procedure has been performed, the awning must beserviced by a Dometic service center or a qualified service technician before using again.There are two methods of rolling up the awning if it appears there is no power to the awning motor. Thefollowing method should be performed first:1. When the power awning hardware is in the open position and the 12 VDC power has been lost the awning canbe closed by supplying auxiliary power to the hardware. Connect the awning motor to an external 12 VDCpower source via user-supplied wire (16 gauge minimum). A good external 12 VDC power source would be anautomobile battery.2. Locate and unplug the motor and hardware cable connection located in the upper part of the right hand arm.3. Connect the user-supplied wire leads to the terminals in the connector from the motor. Electrical tape may berequired to keep the wire leads in place. (Do not connect to the one in the hardware).4. Connect the other end to a 12 VDC battery source. The red wire goes to + and the black to -. If there is not aproblem with the awning motor, this will retract the awning. To avoid motor damage disconnect battery sourceimmediately after awning is fully retracted.12-3

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!