CIMCO

82The default values shown in the dialog arebased on the cutting moves in the NCprogram.Since the tool moves down in cutting speed,the Z-max will nearly always be too big.The same is the case for the facing operation.That will give a too large stock along boththe X- and Y- axis.From the facing operation we know that thetop of the stock should be Z:2.00.From the drawing we know that the valuesof the corners are (0.00, 0.00) and (150.00,100.00).We now make the stock 2mm larger alongX- and Y-axis, so the values will be the onesshown in the dialog on the right.Please enter these and exit the dialog withOK.