DC3500 AT Commands Manual 500242R01 ... - Cooking Hacks

DC3500 AT Commands Reference Manual 500242R019.29. Selective polling address +FPADescriptionThis command sets the selective polling address. The DCE sends the numeric string contained in the+FPA at the times specified in T.30, if the corresponding parameter is not zero string.SyntaxCommand syntax: AT+FPA=Defined values 20 digit string; valid values 0-9, *, #, space9.30. Local polling ID string +FPIDescriptionThis command allows the DCE to send the ID frame if +FPI is not a zero string. Polling is notsupported.SyntaxCommand syntax: AT+FLI=Defined values only zero string; polling is not supported.9.31. Packet protocol control +FPPDescriptionThis command allows to control the packet protocol. The packet protocol is not supported.SyntaxCommand syntax: AT+FPP=[]Defined values only value 0 allowed.9.32. Page status +FPSDescriptionThis parameter contains a value representing the post age response, including copy quality andrelated end-of-page statusSyntaxCommand syntax: AT+FPS=[]Defined values may be:- 1: MCF, page good- 2: RTN, page bad; retrain requested- 3: RTP, page good; retrain requested- 4: PIN, page bad; interrupt requested- 5: PIP, page good; interrupt requestedConfidential DAVISCOMMS (S) PTE LTD 96 /136