User Controls - Lampe-videoprojecteur.info

More documents

Recommendations

Info

Appendices Over temperature: Replacing the lamp:Remote Control ProblemsIf the remote control does not work Check the operating angle for the remote control is approximately±22.5°.Make sure there are not any obstructions between the remote controland the projector. Move to within 6 m (20 ft) of the projector. Make sure batteries are inserted correctly. Make sure batteries are exhausted. If so, replace weak batteries inthe remote control.40
AppendicesReplacing the lampThe projector automatically detects the lamp life. When the lamplife is nearing the end of use, you will receive a warning message.EnglishWarning: Lamp compartmentis hot! Allow service center to change the lamp as soon as possible. Make sureWhen you see this message, please contact your local reseller orit to cool down beforethe projector has been cooled down for at least 30 minutes beforechanging lamp!changing the lamp.1324Warning: To reduce therisk of personal injury,do not drop the lampmodule or touch thelamp bulb. The bulbmay shatter and causeinjury if it is dropped.Lamp Replacing Procedure:1. Switch off the power to the projector by pressing the Powerbutton.2. Allow the projector to cool down at least 30 minutes.3. Disconnect the power cord.4. Use a screwdriver to remove the screw from the cover.5. Push up and remove the cover.6. Remove the 2 screws from the lamp module.7. Pull out the lamp module. To replace the lamp module, reverse the previous steps.8. Turn on the projector and do “Lamp Reset” after the lampmodule is replaced.Lamp Reset: (i)Press “Menu” -> (ii)Select “System” ->(iii)Select “Lamp setting” ->(iv)Select “Lamp reset” ->(v)Select “Yes”.41
Page 1 and 2: Table of contentsTable of Contents
Page 3: Usage NoticePrecautionsNoteWhen the
Page 8: IntroductionProduct OverviewMain Un
Page 11 and 12: IntroductionRemote Control1English1
Page 13 and 14: InstallationPowering On/Off the Pro
Page 15 and 16: InstallationAdjusting the Projected
Page 18 and 19: User ControlsUsing the Remote Contr
Page 20 and 21: User ControlsOn-screen Display Menu
Page 22 and 23: User ControlsImageNote“Image mode
Page 24 and 25: User ControlsImage | AdvanceNoise R
Page 26 and 27: User ControlsDisplayFormatUse this
Page 28 and 29: User ControlsV KeystonePress the or
Page 30 and 31: User ControlsHigh AltitudeChoose
Page 32 and 33: User ControlsSystemMenu LocationCho
Page 34 and 35: User Controls12V Trigger STD: When
Page 36 and 37: AppendicesNote(*) The resolution:HD
Page 38 and 39: AppendicesImage is out of focus Mak
Page 42 and 43: AppendicesNoteCompatibility ModesMo
Page 44 and 45: RS232 Protocol Function ListInterfa
Page 46 and 47: AppendicesCeiling Mount Installatio
Page 48 and 49: AppendicesTaiwan231, 台北縣
Page 50: AppendicesOperation conditionsThis

User Controls - Lampe-videoprojecteur.info

Create successful ePaper yourself

Delete template?

Save as template?