EZ-Guide Plus Lightbar Guidance System Getting Started Guide

Using the vehicle cigarette lighterIf the power cable is plugged into a cigarette lighter that is not wired through thevehicle ignition, the lightbar receives power whenever the cable is plugged in. To avoiddraining the vehicle battery, turn off or disconnect the lightbar from the power sourceif the vehicle will be unused for an extended time.Minimizing GPS signal interferenceTo minimize any interference to the GPS signal, make sure that the GPS antenna is atleast 1 m (3 ft) from any other antenna (including a radio antenna), and at least100 m (300 ft) from any power line, radar dish, or cell phone tower.Connecting to other devices• To use the remote control or an external GPS receiver or an external sensor (forexample, yield monitor), attach it directly to the lightbar data port connector.• To use the remote control and an externalreceiver or sensor, connect them usingthe optional external interface cable.Note — You cannot connect an externalGPS receiver and external sensor at thesame time.• To connect a spray switch or device toreceive speed pulse outputs, use theoptional external interface cable.To GPSor externalsensor Switch inputor pulse outputFor information on configuring the data port settings, see Using GPS, page 41.12 Introduction EZ-Guide Plus Lightbar Guidance System Getting Started Guide