EZ-Guide Plus Lightbar Guidance System Getting Started Guide

Resetting guidance1. Select 9. The Guidance Pattern screen appears.2. Press u or D to choose the required pattern andthen press o.A message appears asking you to confirm yourchoice. This prevents accidental resetting of theguidance pattern.3. To confirm, press o.Configuring the swath widthOnce you select a pattern, the Swath/Implement screenappears.BBTo change the swath width value:1. Select the Swath Width field.2. Press u or D until the correct value is displayed.3. Press o.Tip — To avoid skips between swaths, set the swath width to 0.3 m (1 ft) less thanthe total implement width.If the vehicle has an implement that is offset to one side of the vehicle, configure animplement offset:1. Select the Impl. Offset field.2. Press u or D until the correct value is displayed.3. Press o.Tip — If an implement offset is configured, the guidance arrow will represent thecenter of the implement, instead of the center of the vehicle.Note — In some adaptive curves, tight U-turns with an implement offset may not bedetected if the implement does not follow the path of a U-turn. If this occurs, setGuidance / Auto-detect Turn to Off, manually set B, and then turn onto the nextcurve.Using guidance patternsThis section describes how to define and use each of the available guidance patterns.The AB Line is a line that runs between Point A and Point B, although you may notalways set a Point B. In most cases, the AB Line is the reference line for subsequentswaths.The start and end of the initial swath that defines the swath pattern appear on thelightbar screen as a circle (Point A) and a square (Point B).24 Getting Guidance EZ-Guide Plus Lightbar Guidance System Getting Started Guide