EZ-Guide Plus Lightbar Guidance System Getting Started Guide

DGPS box receiverThe following figure shows how to connect the DGPS box receiver to the lightbar.LightbarP/N 52026-00P/N 52033DGPS box receiverP/N 30945-00Optional remote controlTo switch inputand pulse outputIf you are using a DGPS box receiver, you need to disable the 1HZ VTG setting:1. From the Home screen, press 3 until Configuration appears and then press2.2. Press 3 until the GPS Config screen appears.3. Press 2 until the 1Hz NMEA screen appears.4. Change VTG to vtg as follows:a. Press 3 to highlight VTG.b. Press 2 to change VTG to vtg.c. Press 4 to save the setting.Selecting the correct OmniSTAR satellite manually1. From the Home screen, press 3 until the Configuration screen appears.2. Press 2 and then press 3 until the DGPS Config screen appears.3. Press 2 until the DGPS Source screen appears.4. Press 3 and then 2 to change the setting to OmniSTAR.5. Press 2 until the EZ Sat: Omni* screen appears.6. Press 3 and then 2 to select the correct region.EZ-Guide Plus Lightbar Guidance System Getting Started Guide Using GPS 51