EZ-Guide Plus Lightbar Guidance System Getting Started Guide

Note — Make sure that you are not within one swath width of the start point. Ifyou are, Point B will not be set.6. Turn into the field. The next swath is generated off the last pass.7. On each pass, when you are nearly back to where you started the headland, resetPoint B to mark the end of the swath.Rowfinder (using Adaptive curve pattern)When you drive with an implement that spans several rows, you can navigate to thenext appropriate swath without having to count the rows in between yourself.To use the Adaptive Curve pattern to count the rows that you can skip:1. Select Guidance / Auto-detect Turn and setB B BAuto-turn to Off.2. Reset guidance and then select the Adaptive Curvepattern.3. Select the Swath Width value that matches thewidth of your implement.A B4. Mark Point B at the end of the row.B5. Find the next row to drive down by turning until yousee three green LEDs on the lightbar.Headlands patternUse the Headlands pattern when:• you need to apply the headland area first, to give you room to turn when you applythe straight swaths• you want to know the area of the fieldYou can do as many headland circuits as required before you change to straightswaths. The Headlands pattern automatically increments to the next headland whenyou enter the circle around the start point of the headland.Tip — To pause, zoom, or change the headland view, click the appropriate icon.Multiple headlands1. Start a headland.2. Drive around the field area. The headland isrecorded.3. When you return to the headland start point,the next headland swath is automaticallygenerated.Step 18Step 4DStep 5AStep 6B28 Getting Guidance EZ-Guide Plus Lightbar Guidance System Getting Started Guide