Commercial Treadmill Owner's Manual

C O M M E R C I A L P R O D U C T S D I V I S I O NDiagram 7Attach thedisplay consoleto the left uprightsupport.Display consoleDisplay cableScrews (A) withwashers (B)Left side uprightsupportCAUTION: To avoid damage to the display cable, read the following stepscarefully. Damage to the cable due to improper assembly is not coveredby the Precor limited warranty.6. Secure the display console to the left upright support. Diagram 7.Remove any tape or wire ties that secure the display cable. Unwrap the cableto remove kinks. Ask an assistant to hold the display console in place whileyou attach it to the left upright support using two buttonhead screws (A) withwasher (B). Finger tighten.Diagram 8Remove rightside front panelscrews.Right sidemounting bracketFront panelfasteners7. Prepare to attach the right side upright. Diagram 8. Take the following steps:a. Remove the shipping fasteners from the right front panel. Follow the sameprocess as in step 5a. With the supplied hex key and a ¹⁄₂-inch box end wrench,loosen and remove the two bolts and nuts on the right side of the front panel.page 13