Commercial Treadmill Owner's Manual

C O M M E R C I A L P R O D U C T S D I V I S I O NDiagram 11Secure the rightupright support.Screws (D),washers (E),and barrelspacers (F)Tighten so thatthe upright issecure, butleave room foradjustments.Front panel1Shippingfasteners withwashers (B)238. Secure the right side upright support. Diagram 11. Obtain two longsockethead screws (D), washers (E) and barrel spacers (F) from the Hardwarekit. Place a washer and barrel sleeve on each bolt and insert the fastenersthrough the side of the upright support and into the base mounts. Diagram 11,#1. Secure the upright support using the ¼-inch hex key. See Diagram 11, #2.Important: Do not securely tighten the screws until after the unit has been fullyassembled. Make sure that the bolt and spacer do not pinch the cable.9. Remove two stainless steel washers (B) from the Hardware kit and place one oneach of the two bolts removed in step 7a. Reinsert the bolts and finger tighten.Diagram 11, #3.Diagram 12Secure thedisplay console.Display console1-inch screws (A)with washers (B)Tighten thescrews, butleave room foradjustments.10. Secure the display console to the upright supports. Diagram 12, #1. Alignthe display console with the right side upright support mounts. Insert two 1-inchscrews (A) with washers (B) and finger tighten. Use the supplied hex key tosecure the screws on both upright supports, but leave room for adjustments.See inset in Diagram 12, #2.page 15