Cisco Unified Communications Manager

More documents

Recommendations

Info

Enabling endpoints registered on the VCS Control to call endpoints registered on CUCMDestination port 5060Presence GroupSIP Trunk Security ProfileSIP ProfileDTMF Signaling MethodStandard Presence Group (or whichever presencegroup has been configured in System > PresenceGroup)Non Secure SIP Trunk ProfileStandard SIP ProfileNo preference9. Click Save.10. Click Reset.11. Click Reset.Calls can now be made between handsets registered on the VCS Control to handsets registered onCUCM.VCS Control configurationThe configuration of the VCS Control just needs 1 step: Configure the VCS Control with a neighbor zone that contains the CUCM.VCS ControlLOCAL ZONETraversalSubzoneLocal Video EndpointSubzoneNeighborZoneDefaultSubzoneDefaultZoneDNSZoneENUMZoneCreate a neighbor zone for CUCM1. Go to VCS Configuration > Zones.2. Click New.TANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 18 of 43
Enabling endpoints registered on the VCS Control to call endpoints registered on CUCM3. Configure the fields as follows:NameCUCM NeighborTypeNeighborHop count 15Note: The VCS Control is to use SIP over TCP to communicate with the CUCM. If you want to useTLS, complete the configuration as described here for TCP and then refer to Appendix 10 –Connecting VCS to CUCM using TLS (rather than TCP).4. Configure the fields as follows:H.323 mode OffH.323 access is not required for communication with CUCMSIP modeOnSIP port 5060If the SIP access port on CUCM is not 5060, change the SIP Port valueto be the same as used by CUCMTransportTLS verify modeAuthenticationtrust modeAccept proxiedTCPOffOffAllowTANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 19 of 43
Page 1 and 2: Cisco UnifiedCommunications Manager
Page 3 and 4: ContentsLook at “Call history”
Page 5 and 6: IntroductionIntroductionObjectives
Page 7 and 8: Enabling calls between endpoints re
Page 15 and 16: Enabling endpoints registered on th
Page 17: Enabling endpoints registered on th
Page 21 and 22: Enabling endpoints registered on th
Page 23 and 24: Enabling endpoints registered on CU
Page 25 and 26: Enabling endpoints registered on CU
Page 27 and 28: Appendix 1 - TroubleshootingLook at
Page 29 and 30: Appendix 1 - TroubleshootingVCS Rep
Page 31 and 32: Appendix 2 - Known interworking cap
Page 33 and 34: Appendix 4 - Allow dialing to VCS d
Page 35 and 36: Appendix 5 - Connecting CUCM to a c
Page 37 and 38: Appendix 7 - Endpoint specific conf
Page 39 and 40: Appendix 9 - CUCM 5 incompatibility
Page 41 and 42: Appendix 10 - Connecting VCS to CUC
Page 43: Disclaimers and noticesDisclaimers

Cisco Unified Communications Manager

Create successful ePaper yourself

Delete template?

Save as template?