Cisco Unified Communications Manager

More documents

Recommendations

Info

Enabling endpoints registered on CUCM to call endpoints registered on the VCS ControlEnabling endpoints registered on CUCM to callendpoints registered on the VCS ControlVCS Control configurationThe configuration of the VCS Control needs 1 step: Configure the VCS Control with a search rule that takes the incoming domain information put onby CUCM (IP address of VCS:IP port) and converts it to the sip domain used by the registeredendpoints and routes the call to the Local Zone. The transform also needs to expand a received“short” 4 digit number to a full 11 digit phone number, as endpoints register with their full 11 digits.VCS ControlLOCAL ZONETraversalSubzoneLocal Video EndpointSubzoneNeighborZoneDefaultSubzoneDefaultZoneDNSZoneENUMZoneSet up a search rule for CUCM to call the VCS Local ZoneNote: The search rule needs to match and transform the URI received from CUCM(0118912)?(4xxx@:5060) into 01189124xxx@vcs.domain1. Select VCS Configuration > Search rules > Rules2. Click New.TANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 22 of 43
Enabling endpoints registered on CUCM to call endpoints registered on the VCS ControlNote: This search rule will handle all calls to URIs in the format (0118912)?(4…)@:5060 and transform them to 0118912\2@vcs.domain, e.g. in this scenario,01189124000@10.44.9.214:5060 will be converted to 01189124000@vcs.domain and4000@10.44.9.214:5060 will also be converted to 01189124000@vcs.domain3. Configure the fields as follows:Rule nameDescriptionPriority 40SourceModePattern typePattern stringPattern behaviorReplace stringOn successful matchTarget zoneState4. Click Create search rule.CUCM to registered devicesFor example: (0118912)? 4xxx@10.44.9.214:5060 to callregistered endpointsAnyAliasPatternMatchRegex(0118912)?(4…)@10.44.9.214:5060Replace0118912\2@vcs.domainStopLocalZoneEnabledTANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 23 of 43
Page 1 and 2: Cisco UnifiedCommunications Manager
Page 3 and 4: ContentsLook at “Call history”
Page 5 and 6: IntroductionIntroductionObjectives
Page 7 and 8: Enabling calls between endpoints re
Page 15 and 16: Enabling endpoints registered on th
Page 21: Enabling endpoints registered on th
Page 25 and 26: Enabling endpoints registered on CU
Page 27 and 28: Appendix 1 - TroubleshootingLook at
Page 29 and 30: Appendix 1 - TroubleshootingVCS Rep
Page 31 and 32: Appendix 2 - Known interworking cap
Page 33 and 34: Appendix 4 - Allow dialing to VCS d
Page 35 and 36: Appendix 5 - Connecting CUCM to a c
Page 37 and 38: Appendix 7 - Endpoint specific conf
Page 39 and 40: Appendix 9 - CUCM 5 incompatibility
Page 41 and 42: Appendix 10 - Connecting VCS to CUC
Page 43: Disclaimers and noticesDisclaimers

Cisco Unified Communications Manager

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?