Cisco Unified Communications Manager

Enabling endpoints registered on CUCM to call endpoints registered on the VCS ControlEnabling endpoints registered on CUCM to callendpoints registered on the VCS ControlVCS Control configurationThe configuration of the VCS Control needs 1 step: Configure the VCS Control with a search rule that takes the incoming domain information put onby CUCM (IP address of VCS:IP port) and converts it to the sip domain used by the registeredendpoints and routes the call to the Local Zone. The transform also needs to expand a received“short” 4 digit number to a full 11 digit phone number, as endpoints register with their full 11 digits.VCS ControlLOCAL ZONETraversalSubzoneLocal Video EndpointSubzoneNeighborZoneDefaultSubzoneDefaultZoneDNSZoneENUMZoneSet up a search rule for CUCM to call the VCS Local ZoneNote: The search rule needs to match and transform the URI received from CUCM(0118912)?(4xxx@:5060) into 01189124xxx@vcs.domain1. Select VCS Configuration > Search rules > Rules2. Click New.TANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 22 of 43