Cisco Unified Communications Manager

More documents

Recommendations

Info

Enabling endpoints registered on the VCS Control to call endpoints registered on CUCMregistrationsPeer 1 addressZone profile(Advanced section)IP address of CUCM, or the domain of CUCMSelect Cisco Unified Communications Manager.See ‘Appendix 8 – Advanced parameters set by the “Cisco UnifiedCommunications Manager” zone profile’ for details on what is configuredby this setting.5. Click Create zone.6. Go to VCS Configuration > Search rules > Rules.7. Click New.Note: Search rules are used to specify the range of telephone numbers / URIs that will be handled bythis neighbor CUCM. Search rules can also be used to transform URIs before they are sent to theneighbor.In this implementation the transforms set up in the “Create transforms” section above have alreadymade sure that dial strings are in URI format number@vcs.domain. As CUCM requires dialednumbers to be in the form 3xxx@ a transform will be required to convert callsto CUCM which are addressed 3xxx@vcs.domain to that format.8. Configure the fields as follows to convert called IDs in the format 3xxx@vcs.domain to3xxx@ and then route the call to CUCM:Rule nameDescriptionPriority 100SourceModePattern typePattern stringPattern behaviorReplace stringOn successful matchTarget zoneState9. Click Create search rule.Route to CUCMFor example: Send 3xxx@vcs.doman calls to CUCMAnyAliasPatternMatchRegex(3\d{3})@vcs.domainReplace\1@, for example \1@10.1.2.22StopCUCM NeighborEnabledTANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 20 of 43
Enabling endpoints registered on the VCS Control to call endpoints registered on CUCMSee the “Zones and Neighbors” section of the VCS Administrator Guide for further details.Test callsMake some test calls from endpoints registered on the VCS Control to endpoints registered on CUCMby dialing the required CUCM extension number (3xxx) on the VCS endpoint.On endpoints registered to the VCS dial the extension numbers of endpoints registered on CUCM, forexample 3000.TANDBERG Deployment Guide: CUCM v6.1, 7 and 8 with VCS X5.1 using a SIP trunk Page 21 of 43
Page 1 and 2: Cisco UnifiedCommunications Manager
Page 3 and 4: ContentsLook at “Call history”
Page 5 and 6: IntroductionIntroductionObjectives
Page 7 and 8: Enabling calls between endpoints re
Page 15 and 16: Enabling endpoints registered on th
Page 17 and 18: Enabling endpoints registered on th
Page 19: Enabling endpoints registered on th
Page 23 and 24: Enabling endpoints registered on CU
Page 25 and 26: Enabling endpoints registered on CU
Page 27 and 28: Appendix 1 - TroubleshootingLook at
Page 29 and 30: Appendix 1 - TroubleshootingVCS Rep
Page 31 and 32: Appendix 2 - Known interworking cap
Page 33 and 34: Appendix 4 - Allow dialing to VCS d
Page 35 and 36: Appendix 5 - Connecting CUCM to a c
Page 37 and 38: Appendix 7 - Endpoint specific conf
Page 39 and 40: Appendix 9 - CUCM 5 incompatibility
Page 41 and 42: Appendix 10 - Connecting VCS to CUC
Page 43: Disclaimers and noticesDisclaimers

Cisco Unified Communications Manager

Create successful ePaper yourself

Delete template?

Save as template?