- Page 1 and 2:
Development of an Instrument Landin
- Page 3 and 4:
Approval PageTITLE: Development of
- Page 5:
AcknowledgementsI would like to tha
- Page 8 and 9:
Figure 17: Front Cockpit IOS.......
- Page 10 and 11:
4.7.2 Throttle Calibration.........
- Page 12 and 13:
the simulation is transportable to
- Page 14 and 15:
development. These models had to be
- Page 16 and 17:
and right views respectively.Spiege
- Page 18 and 19:
The stick is connected to the stick
- Page 20 and 21:
Currently, the only console card in
- Page 22 and 23:
an output, it is sent from either t
- Page 24 and 25:
2.3 Computer SoftwareThe four compu
- Page 26 and 27:
2.3.4 TCP-IP/UDPSince the computers
- Page 28 and 29:
2.4 Analog OutputThe simulation sen
- Page 30 and 31:
This channel also is etched into th
- Page 32 and 33:
3. Simulation Operations Procedures
- Page 34 and 35:
3.2.1.2 Engine ModelThe engine mode
- Page 36 and 37:
3.2.1.5 Instrument ModelThe instrum
- Page 38 and 39:
3.2.2.1 Times Two TutorialThis is a
- Page 40 and 41:
4.1.1 Terrain DatabaseFurther devel
- Page 42 and 43:
showing the pilot where he needs to
- Page 44 and 45:
4.6 ProjectorsThe Visuals for the P
- Page 46 and 47:
Table 1: Instrument Calibration Che
- Page 48 and 49:
By adjusting the potentiometersetti
- Page 50 and 51:
5. Simulator Implementation:The mos
- Page 52 and 53:
5.4 Guidance and ControlsThe simula
- Page 54 and 55:
and visually see how an aircraft pe
- Page 56 and 57:
14. Hill and Peterson, Mechanics an
- Page 58 and 59:
Documentation:Introduction to Pheag
- Page 60 and 61:
Stick ModelBelow is the Stick Model
- Page 62 and 63:
SixDOF ModelThis page describes the
- Page 64 and 65:
Standard Atmosphere ModelThis page
- Page 66 and 67:
Tutorial #1: Times Two TutorialThis
- Page 68 and 69:
Tutorial #2: Speed of Sound Tutoria
- Page 70 and 71:
B.1 Engine_Mod.c/* S-function engin
- Page 72 and 73: * Also see Pheagle_HTML** Copyright
- Page 74 and 75: ssSetInputPortWidth(S, 0, 13);//12
- Page 76 and 77: * TSFCslAB=*uPtrs[8];* rho=*uPtrs[9
- Page 78 and 79: y[6]=RRPM;y[7]=LRPM;y[8]=RTemp;y[9]
- Page 80 and 81: High By-pass Engine: Engine Type =
- Page 82 and 83: LThrust=LThrottle*Thrust;//printf("
- Page 84 and 85: Calculate the Left Engine Nozzle Po
- Page 86 and 87: B.2 Spool.c/***********************
- Page 88 and 89: {ssSetNumSFcnParams(S, 0);if (ssGet
- Page 90 and 91: * Initialize the state. Note, that
- Page 92 and 93: * for performing any tasks that sho
- Page 94 and 95: * S-function ils_modelB.3 ILS_Model
- Page 96 and 97: #define S_FUNCTION_NAME ils_model//
- Page 98 and 99: * Function: mdlInitializeSampleTime
- Page 100 and 101: {InputRealPtrsType uPtrs = ssGetInp
- Page 102 and 103: Theta2 = pi+Theta1;Theta3 = -((2*pi
- Page 104 and 105: B.4 Server.c/**********************
- Page 106 and 107: struct sockaddr_in you; // the outg
- Page 108 and 109: #define MDL_START#if defined(MDL_ST
- Page 110 and 111: {// This function sets the server s
- Page 112 and 113: B.5 Server.h/**********************
- Page 114 and 115: B.6 Slave.c/***********************
- Page 116 and 117: ***********************************
- Page 118 and 119: create the socketsocket_num=socket(
- Page 120 and 121: host_data.ownrot.x = psi;host_data.