Developement Of An Instrument Landing Simulation ... - Cal Poly

More documents

Recommendations

Info

B.2 Spool.c/*********************************************************************MODULE:spool.c* AUTHOR(S): Robert A. Barger, Michael Ortner, Jeff Doll* DATE: September 25, 1998* Copyright (c) ALL RIGHTS RESERVED* <strong>Cal</strong> <strong>Poly</strong> San Luis Obispo 1998** REVISION HISTORY:* REV AUTHOR DATE DESCRIPTION* 0 rab 5-11-oo Creation of code and Simulink Model** S-mex: See simulink/src/sfuntmpl.doc* S-mex Copyright (c) 1990-1998 by The MathWorks, Inc. All Rights Reserved.* $Revision: 1.3** This S-function block Reads the commanded throttle position and determines* whether the engines are spooling up or spooling down. The program keeps track* of the last position and if the difference is positive then the engine is* spooling down else it is spooling up. The spool up time delay was set to 0.5 sec* and the spool down time delay was set to 0.25 sec.********************************************************************/#define S_FUNCTION_NAME spool76
#define S_FUNCTION_LEVEL 2#include "simstruc.h"#include //#include #include #include #include #include #include #include double oldVals[2];double LThrottle, RThrottle;int LTauDN=0;int RTauDN=0;/* Function: mdlInitializeSizes=======================================* Abstract:* Setup sizes of the various vectors. */static void mdlInitializeSizes(SimStruct *S)77
Page 1 and 2:
Development of an Instrument Landin
Page 3 and 4:
Approval PageTITLE: Development of
Page 5:
AcknowledgementsI would like to tha
Page 8 and 9:
Figure 17: Front Cockpit IOS.......
Page 10 and 11:
4.7.2 Throttle Calibration.........
Page 12 and 13:
the simulation is transportable to
Page 14 and 15:
development. These models had to be
Page 16 and 17:
and right views respectively.Spiege
Page 18 and 19:
The stick is connected to the stick
Page 20 and 21:
Currently, the only console card in
Page 22 and 23:
an output, it is sent from either t
Page 24 and 25:
2.3 Computer SoftwareThe four compu
Page 26 and 27:
2.3.4 TCP-IP/UDPSince the computers
Page 28 and 29:
2.4 Analog OutputThe simulation sen
Page 30 and 31:
This channel also is etched into th
Page 32 and 33:
3. Simulation Operations Procedures
Page 34 and 35:
3.2.1.2 Engine ModelThe engine mode
Page 36 and 37: 3.2.1.5 Instrument ModelThe instrum
Page 38 and 39: 3.2.2.1 Times Two TutorialThis is a
Page 40 and 41: 4.1.1 Terrain DatabaseFurther devel
Page 42 and 43: showing the pilot where he needs to
Page 44 and 45: 4.6 ProjectorsThe Visuals for the P
Page 46 and 47: Table 1: Instrument Calibration Che
Page 48 and 49: By adjusting the potentiometersetti
Page 50 and 51: 5. Simulator Implementation:The mos
Page 52 and 53: 5.4 Guidance and ControlsThe simula
Page 54 and 55: and visually see how an aircraft pe
Page 56 and 57: 14. Hill and Peterson, Mechanics an
Page 58 and 59: Documentation:Introduction to Pheag
Page 60 and 61: Stick ModelBelow is the Stick Model
Page 62 and 63: SixDOF ModelThis page describes the
Page 64 and 65: Standard Atmosphere ModelThis page
Page 66 and 67: Tutorial #1: Times Two TutorialThis
Page 68 and 69: Tutorial #2: Speed of Sound Tutoria
Page 70 and 71: B.1 Engine_Mod.c/* S-function engin
Page 72 and 73: * Also see Pheagle_HTML** Copyright
Page 74 and 75: ssSetInputPortWidth(S, 0, 13);//12
Page 76 and 77: * TSFCslAB=*uPtrs[8];* rho=*uPtrs[9
Page 78 and 79: y[6]=RRPM;y[7]=LRPM;y[8]=RTemp;y[9]
Page 80 and 81: High By-pass Engine: Engine Type =
Page 82 and 83: LThrust=LThrottle*Thrust;//printf("
Page 84 and 85: Calculate the Left Engine Nozzle Po
Page 88 and 89: {ssSetNumSFcnParams(S, 0);if (ssGet
Page 90 and 91: * Initialize the state. Note, that
Page 92 and 93: * for performing any tasks that sho
Page 94 and 95: * S-function ils_modelB.3 ILS_Model
Page 96 and 97: #define S_FUNCTION_NAME ils_model//
Page 98 and 99: * Function: mdlInitializeSampleTime
Page 100 and 101: {InputRealPtrsType uPtrs = ssGetInp
Page 102 and 103: Theta2 = pi+Theta1;Theta3 = -((2*pi
Page 104 and 105: B.4 Server.c/**********************
Page 106 and 107: struct sockaddr_in you; // the outg
Page 108 and 109: #define MDL_START#if defined(MDL_ST
Page 110 and 111: {// This function sets the server s
Page 112 and 113: B.5 Server.h/**********************
Page 114 and 115: B.6 Slave.c/***********************
Page 116 and 117: ***********************************
Page 118 and 119: create the socketsocket_num=socket(
Page 120 and 121: host_data.ownrot.x = psi;host_data.
Page 122 and 123: B.7 ModHostData.h/*****************
show all

Developement Of An Instrument Landing Simulation ... - Cal Poly

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?