Hand-held Pendant Stations - EUCHNER GmbH + Co. KG

Hand-held Pendant Stations HBL KitHousing HBLffRubber-coated mounting magnet onthe rear of housingffHanging clipff6 screws for front panel fasteningffCover frame for front panelffFixing domes for printed circuit boardinstallationDimension drawingDepending on version:ffFastening nut for cable gland Pg 11or Pg 13.5ffHole for emergency stop deviceff2 pushbuttons ZSG, 2-stage,2 NO contacts each, e.g. for enablingfunctionffHole on left for enabling switch ZSENotesffEmergency stop devices see page 56ffEnabling switch ZSE see page 57ffCable glands see page 53ffAssembly drawings see page 75ffPg 11 for cable diameter 5 ... 10 mmffPg 13.5 for cable diameter 6 ... 12 mmPushbutton ZSGon both sidesScrew-in depthmax. 6.0(applies to allmounting holes)View AHanging clipMounting magnetHole forenabling switch ZSE2-4∅ DATechnical dataParameter Value UnitHousing HBLMaterialPlasticColor Blue-gray RAL 7031Ambient temperature 0 ... +55 °CDegree of protection according to EN 60529 / NEMA IP 65 / 250-12Pushbutton ZSG, 2-stage, e.g. for enabling functionSwitching elements2, 2 NO contacts eachUtilization category according to IEC 947-5-1AC-15 U e 24 V I e 4 ADC-13 U e 24 V I e 3 A42Subject to technical modifications; no responsibility is accepted for the accuracy of this information. Devices supplied may vary slightly from the illustration in the catalog.