RCS1100 Series - Engineering Surveyor

Activate/Deactivate Work Area (WORK+/WORK-)Lock interruption / Lock goActivates the functionactivate/deactivateworking area.If the instrument is in RCS mode andthe determined working area isactivated then the entire workingarea is scanned for the reflector ifthe target was not found by thestandard search method at thecurrent position of the telescope.If the working area is deactivatedonly the standard search methods atthe current position of the telescopeare performed.The instrument follows the reflectoreven if the reflector is outside theWorking Area.On instruments with the optionalPowerSearch, the working area canbe used to limit PowerSearch to acertain area and when activated,PowerSearch only scans within thedefined limits.Last point storedActivates the LASTfunction.If the LOCK mode is lost, thisfunction can be used to turn theTPS1100 back to the last pointstored. When the movement iscomplete, the TPS1100 automaticallystarts to search for the prism.Activates the lockinterruption/relock.This function serves to interrupt theLOCK mode and later to reinstate it,e.g. if the prism is placed on theground during stakeout or if theTPS1100 is also to be targeted on asecond prism.If this function is called up inthe RCS-mode the Joystickdialog is automatically started. TheATR remains active, i.e. if thereflector reappears in the field ofview it is immediately relocked.67815If the target is lost outsidethe Working Area a localsearch will be started. If the reflectorwas not found the predefinedWorking Area is scanned.Switching the RCS modeSwitches on/off theRCS mode.For using the remote control theRCS mode must be switched on.RCS1100-1.2.0en23Operation