RCS1100 Series - Engineering Surveyor

FCC statement (applicable in U.S.)Only for RCS1100 without integrated radiomodem:WARNING:This equipment has been tested and found tocomply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonableprotection against harmful interference in a residentialinstallation.This equipment generates, uses and can radiatefrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee that interference will notoccur in a particular installation.If this equipment does cause harmful interference toradio or television reception, which can be determined byturning the equipment off and on, the user is encouragedto try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment andreceiver.• Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.• Consult the dealer or an experienced radio/TVtechnician for help.WARNING:Changes or modifications not expresslyapproved by Leica Geosystems for compliancecould void the user's authority to operate the equipment.Product labelling:This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference received,including interference that may cause undesired operation.Type: RCS1100Art.No.: .667173Power: 12V/6V ---,This devicecontains atransmitter:FCC ID:HSW-2400MSSDL-10.4Amax; EPR:100mWLeica Geosystems AGCH-9435 HeerbruggManufactured: 2002Made in Switzerland S.No.: #$1#!This device complies withpart 15 of the FCC Rules.Operation is subject tothe following twoconditions: (1) Thisdevice may not causeharmful interference, and(2) this device mustaccept any interferencereceived, includinginterference that maycause undesiredoperation.Tcs11z03Safety directions40RCS1100-1.2.0en