warning - Sea-Doo.net

O.P.A.S. System(if so equipped)The O.P.A.S. system operation andcondition should be checked by anauthorized Sea-Doo dealer.Drive Shaft CorrosionProtectionTo give additional protection to driveshaft against possible corrosion in saltwater conditions, it is recommendedto bring the watercraft to an authorizedSea-Doo dealer for proper lubrication.Ski/Wakeboard Post(if so equipped)Check ski/wakeboard post operation.Ensure it slides up and down easily.Check locking mechanism operation.Check fasteners tightness. If somethingis found defective, don't use ski/wakeboard post and see an authorizedSea-Doo dealer for repair.General Inspection andCleaningInspectionCheck engine compartment for anydamage and for leaks of fuel, coolantor oil. Ensure all hose clamps areproperly secured and no hose iscracked, kinked or presenting anyother damage. WARNINGIf any gasoline leak and/or odor arepresent, do not start the engine.Have the watercraft serviced by anauthorized Sea-Doo dealer. WARNINGPeriodically verify the seat lock pinand tighten if needed. Make sureseat securely latches.CleaningThe bilge should be cleaned by anauthorized Sea-Doo dealer to removeany fuel/oil/electrolyte deposits andmildew.Occasionally, wash the body with waterand soap (only use mild detergent).Remove any marine organisms fromengine and/or hull. Apply non-abrasivewax such as silicone wax.CAUTION: Never clean fiberglassandplasticpartswithstrongdetergent,degreasing agent, paint thinner,acetone, etc.Stains may be removed from seat andfiberglass with Knight's Spray-Ninefrom Korkay System Ltd or the equivalent.To clean the carpets, use 3M CitrusBase Cleaner (24 oz spay can) or theequivalent.Respect the environment by ensuringfuel, oil or cleaning solutions do notdrain into the waterways.Inspect muffler, battery, fuel tank andoil reservoir fastening devices. Visuallycheck electrical connections for corrosionand tightness.Inspect hull and jet pump water intakegrate for damage. Replace or havedamaged parts repaired._____________________ 99