warning - Sea-Doo.net

HullInspect hull for cracks or damage.Jet Pump Water IntakeRemove weeds, shells, debris or anythingelsethatcouldrestricttheflowof water and damage exhaust coolingsystem or propulsion unit. Cleanas necessary. If any obstruction cannot be removed, refer to an authorizedSea-Doo dealer for servicing.BilgeShould water be present in the bilge,tilt the watercraft to the rear and unscrewdrain plugs to completely emptythe bilge.Secure bilge drain plugs. WARNINGMake sure drain plugs are properlysecured prior to launching the watercraftin water.Battery WARNINGVerify tightness of battery cables totheir posts and condition of batteryretaining fasteners. Do not chargeor boost battery while installed.F18J04Y 1 2TYPICAL — INSPECT THESE AREAS1. Water intake2. Ride plateInspect leading edges of the impeller,if they have nicks or bends, performancewill be greatly reduced.Inspect for any possible coolant leakfrom ride plate. WARNINGWhen operating the engine whilethe watercraft is out of the water,theheatexchangerintherideplatemay become very hot. Avoid anycontact with ride plate as burnsmay occur.Fuel TankWith the watercraft horizontal, fill thefuel tank to specified level.Check fuel tank retaining straps/fasteners.Engine Compartment WARNINGShould any leak or gasoline odorbe present, do not start the engine.Refer to an authorized Sea-Doodealer before use.Engine Oil LevelEnsure oil level is appropriate as specifiedin LIQUIDS section. Check for oilleaks on engine and in engine compartment.Engine Coolant LevelEnsure coolant level is appropriate asspecified in LIQUIDS section. Checkfor coolant leaks on engine, in bilgeand from ride plate.66 ______________________