warning - Sea-Doo.net

More documents

Recommendations

Info

NOTE: When trailering 2 watercraft, itmay be necessary to remove the innerwakeboard rack.All ModelsA Sea-Doo cover can protect the watercraft,particularly before driving ondirt roads, to prevent dirt entry throughthe air intake openings.Observe trailering safety precautions.Launching/LoadingCAUTION: Before launching thewatercraft, ensure the bilge drainplugs are fully screwed. After loadingthe watercraft, ensure they areremoved to drain bilge.Storage WARNINGBecause fuel and oil areflammable, have an authorizedSea-Doo dealer inspect the fuelsystem integrity as specified in theperiodic inspection chart.It is recommended that the watercraftbe serviced by an authorized Sea-Doodealer for storage but the following operationscan be performed by you witha minimum of tools.CAUTION: Do not run the engineduring the storage period.Body Rinsing/RepairWash the body with soap and watersolution (only use mild detergent).Rinse thoroughly with fresh water.Remove marine organisms from thehull.CAUTION: Never clean fiberglassandplasticpartswithstrongdetergent,degreasing agent, paint thinner,acetone, etc.For gelcoat repairs, refer to an authorizedSea-Doo dealer. Replace damagedlabels/decals.Fuel SystemSea-Doo fuel stabilizer (or equivalent),can be added in fuel tank to preventfuel deterioration and fuel systemgumming. Follow stabilizer manufacturer'sinstructions for proper use.CAUTION: Fuel stabilizer shouldbe added prior to engine lubricationto ensure fuel system componentsprotection against varnish deposits. WARNINGAlwaysstoptheenginebeforerefueling.Fuel is flammable and explosiveunder certain conditions.Always work in a well ventilatedarea. Do not smoke or allow openflames or sparks in the vicinity. Fueltank may be pressurized, turncap slowly when opening. Neveruse an open flame to check fuellevel. When fueling, keep watercraftlevel. Do not overfill or topoff the fuel tank and leave watercraftin the sun. As temperatureincreases, fuel expands and mightoverflow. Always wipe off any fuelspillage from the watercraft. Periodicallyverify fuel system. Alwaysturn the fuel tank valve (ifso equipped) to OFF position whenthe watercraft is not in use.Engine Oil and FilterReplacementThe oil change and filter should be performedby an authorized Sea-Doo dealer.Exhaust Cooling SystemFlushing and Engine InternalLubricationFlushingConnect a garden hose to cool the exhaustsystem as explained in FLUSH-ING under POST-OPERATION CARE.Bring engine to normal operating temperature._____________________ 101
CAUTION: Properly follow the instructionsgiven in the flushing procedure.Close the water tap, then stop the engine.LubricationPull engine cover upward to remove it.Disconnect ignition coil connectors. WARNINGWhen disconnecting coil fromspark plug, always disconnect coilfrom main harness first. Nevercheck for engine ignition sparkfrom an open coil and/or sparkplug in the engine compartmentas spark may cause fuel vapor toignite.IMPORTANT: Never cut the lockingties of ignition coil connectors. Thiswould allow mixing the wires betweencylinders.Remove ignition coils.CAUTION: Ensure there is no dirtin coil holes prior to removing thespark plugs. Otherwise, dirt wouldfall into cylinder and will damagethe internal components.Remove spark plugs.NOTE: After untightening the sparkplugs, a coil may be used to pull thespark plugs out. Simply bring the coildown to spark plug and "hook" it tothen extract spark plug.Spray BOMBARDIER LUBE or equivalent,in spark plug holes.To prevent fuel to be injected and alsoto cut the ignition at the engine cranking,proceed as follows.While engine is stopped, fully depressthrottle lever and HOLD for cranking.Crank the engine a few turns to distributethe oil on cylinder wall.Apply anti-seize lubricant on spark plugthreads then reinstall them.102 _____________________NOTE: Prior to inserting the ignitioncoil to its location, apply someMolykote 111 grease (P/N 413 707000) around the seal area that touchesthe spark plug hole. After installation,ensure the seal seats properly withthe engine top surface.Reinstall ignition coils. Reconnect ignitioncoil connectors.To reinstall engine cover, push it downwarduntil it snaps.Wipe up any residual water from theengine.Disconnect the garden hose.NOTE: It is recommended to fog theengine valves with BOMBARDIERLUBE. Contact your authorizedSea-Doo dealer.BatteryContact your authorized Sea-Doo dealer.Engine Cooling SystemAntifreeze should be replaced for thestorage period to prevent antifreezedeterioration.The antifreeze replacement and a densitytest should be performed by an authorizedSea-Doo dealer.CAUTION: Improper antifreezemixture might allow freezing of theliquid in the cooling system if vehicleis stored in area where freezingpoint is reached. This would seriouslydamage the engine. Failureto replace the antifreeze for storagemay allow its degradation thatcould result in poor cooling whenengine will be used.Bilge CleaningThe following steps should be performedto provide the watercraft enhancedprotection.
Page 4 and 5:
TABLE OF CONTENTSSAFETY INFORMATION
Page 6 and 7:
VTS (Variable Trim System (if so eq
Page 8 and 9:
SAFETYINFORMATION____________ SAFET
Page 10 and 11:
SAFETY CHECK LISTTo fully appreciat
Page 12 and 13:
Eye protectionVest-type personalflo
Page 14 and 15:
To DoRead and understand all warnin
Page 16 and 17:
Operator/PassengerAwarenessThe wate
Page 18 and 19:
OPERATING RULESOperating a watercra
Page 22 and 23:
LOCATION OF THE IMPORTANT LABELSThe
Page 24 and 25:
Label 1 (cont'd)F16L0PLSOME MODELS_
Page 26 and 27:
Label 3Label 7F00A2QYWARNING / AVER
Page 28 and 29:
Label 14F22A09LLabel 15Label 16F18L
Page 30 and 31:
VEHICLEINFORMATION_________________
Page 32 and 33:
IDENTIFICATION NUMBERSThe main comp
Page 34 and 35:
RXP Models13141237-38-396 251720192
Page 36 and 37:
CONTROLS/INSTRUMENTS/EQUIPMENTSFUNC
Page 38 and 39:
16) Shift LeverA push-pull lever:-
Page 40 and 41:
F18L09011. Function buttonsDisplay
Page 42 and 43:
When you are satisfied with yourcho
Page 44 and 45:
Maintenance InformationWhen the wat
Page 46 and 47:
WARNINGEnsure to properly secure ex
Page 48 and 49:
Engine CompartmentRemoving the seat
Page 50 and 51:
RXP Models3 eyelets are available f
Page 52 and 53: 1 1F18L14YTYPICAL1. Drain plugs2. T
Page 54 and 55: 35) BatteryAll Models except RXPBat
Page 56 and 57: WARNINGCertain components in the en
Page 58 and 59: - When installing a wakeboard on th
Page 60 and 61: LIQUIDSCAUTION: Scrupulously follow
Page 62 and 63: Oil LevelCAUTION: Check level frequ
Page 64 and 65: To prevent antifreeze deterioration
Page 66 and 67: PRE-OPERATION CHECKS WARNINGThe pre
Page 68 and 69: WARNINGWhen operating the engine wh
Page 70 and 71: OPERATING INSTRUCTIONS WARNINGAlway
Page 72 and 73: When first using the watercraft, th
Page 74 and 75: The watercraft behaves differentlyw
Page 76 and 77: F01L5JYGrab the grab handle and pul
Page 78 and 79: Rough Water or PoorVisibility Opera
Page 80 and 81: POST-OPERATION CARE WARNINGAllow en
Page 82 and 83: Attach other end of coupler hose to
Page 84 and 85: Jet Pump Water Intakeand Impeller C
Page 86 and 87: WARNINGWhen disconnecting coil from
Page 88 and 89: MAINTENANCEINFORMATION_____________
Page 90 and 91: GeneralOnly perform servicing proce
Page 92 and 93: DESCRIPTIONI: INSPECT, VERIFY, CLEA
Page 94 and 95: MAINTENANCE WARNINGOnly perform pro
Page 96 and 97: 123F19J02YTYPICAL1. Push on arrow p
Page 98 and 99: Fuses rating are identified, look b
Page 100 and 101: O.P.A.S. System(if so equipped)The
Page 104 and 105: Clean the bilge with hot water and
Page 106 and 107: TROUBLESHOOTINGThe following chart
Page 108 and 109: Information Center MessagesOBSERVAT
Page 110 and 111: OTHEROBSERVATIONLean fuel mixture.R
Page 112 and 113: OTHEROBSERVATIONEngine and/or EMSMo
Page 114 and 115: SPECIFICATIONSENGINETypeVEHICLENumb
Page 116 and 117: CAPACITIESEngine oilVEHICLECooling
Page 118 and 119: FUEL SYSTEMFuelFuel injectionPROPUL
Page 120 and 121: INTERNATIONAL METRIC SYSTEM INFORMA
Page 122 and 123: WARRANTY_____________________ 121
Page 124 and 125: BRP NORTH AMERICA LIMITED WARRANTY:
Page 126 and 127: • Operation with fuels, oils or l
Page 128 and 129: CALIFORNIA EMISSION CONTROL WARRANT
Page 130 and 131: Parts covered for 2005 Sea-Doo pers
Page 132 and 133: BRP INTERNATIONAL LIMITED WARRANTY:
Page 134 and 135: Neither the BRP distributor nor any
Page 136 and 137: CHANGE OF ADDRESS/OWNERSHIPIf your
Page 138: WATERCRAFT MODEL No.HULLIDENTIFICAT
show all

warning - Sea-Doo.net

Create successful ePaper yourself

Delete template?

Save as template?