warning - Sea-Doo.net

WARNINGWhen disconnecting coil fromspark plug, always disconnect coilfrom main harness first. Nevercheck for engine ignition sparkfrom an open coil and/or sparkplug in the engine compartmentas spark may cause fuel vapor toignite.Remove ignition coils.CAUTION: Ensure there is no dirtin coil holes prior to removing thespark plugs. Otherwise, dirt wouldfall into cylinder and will damagethe internal components.Remove spark plugs.NOTE: After untightening the sparkplugs, a coil may be used to pull thespark plugs out. Simply bring the coildown to spark plug and "hook" it tothen extract spark plug.Install new spark plugs if available ordry spark plugs using a rag.Cover spark plug holes with a rag.Crank engine several times whilekeeping throttle fully depressed.Reinstall spark plugs and ignition coils.Install clean dry spark plugs if possible.Reconnect ignition coil connector.NOTE: Prior to inserting the ignitioncoil to its location, apply someMolykote 111 grease (P/N 413 707000) around the seal area that touchesthe spark plug hole. After installation,ensure the seal seats properly withthe engine top surface.To reinstall engine cover, push it downwarduntil it snaps.Start engine as explained above. If enginecontinues to flood, see an authorizedSea-Doo dealer.CAUTION: Never run engine withoutsupplying water to the exhaustcooling system when watercraft isoutofwater.Towing the Watercraftin WaterSpecial precautions should be takenwhen towing a Sea-Doo watercraft inwater.Maximum recommended towingspeed is 24 km/h (15 MPH).When towing your watercraft in water,pinch the water supply hose from theimpeller housing to the exhaust manifoldwith a large hose pincher (P/N 529032 500).F01B23YThis will prevent the exhaust coolingsystem from filling which may lead towater being injected into and filling theengine. Without the engine runningthere isn't any exhaust pressure to carrythe water out the exhaust outlet.CAUTION: Failuretodothismayresult in damage to the engine. Ifyou must tow a stranded watercraftin water and do not have a hosepincher, be sure to stay well belowthe maximum towing speed of24 km/h (15 MPH).To ease access to the hose, the venttube can be temporarily removed._____________________ 85