warning - Sea-Doo.net

123F19J02YTYPICAL1. Push on arrow pointing upwardon VTS button2. No interference3. Nozzle upPush on arrow pointing downward onVTS button until VTS stops. The nozzlemust be down and it must not interferewith the venturi.F18L11Y 1TYPICAL1. Vacuum bailer pick-upsFusesIf an electrical problem occurs, checkthe fuses. If a fuse is burnt, replaceby one of the same rating.1F19J03Y1TYPICAL1. Push on arrow pointing downward onVTS button2. No interference3. Nozzle downIf VTS needs to be readjusted, refer toan authorized Sea-Doo dealer.CAUTION: Trim ring and/or nozzleshould not interfere at any position.Vacuum Bailer Pick-UpsThey are located each side of the driveshaft tunnel.Two pick-ups use a low pressure areain the jet pump to siphon the waterout of the bilge when the engine isoperating.Inspect each pick-up screen for obstructions,clean as necessary.23A15E0KZ1. Fuse2. Check if melted3. Ampere ratingFollow procedures below. WARNINGDo not use a higher rated fuse asthis can cause severe damage. Ifa fuse has burnt out, source ofmalfunction should be determinedand corrected before restarting.See an authorized Sea-Doo dealerfor servicing.23_____________________ 95