Tracer AV Installation Manual - Rice Lake Weighing Systems
Tracer AV Installation Manual - Rice Lake Weighing Systems
Tracer AV Installation Manual - Rice Lake Weighing Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2.0 <strong>Installation</strong>This section describes the connections between the DB-9 plugs and the CPU board. This section also includesassembly drawings, connection tables, and parts lists for the service technician.• Use a wrist strap to ground yourself and protect components from electrostatic discharge (ESD) whenworking inside the <strong>Tracer</strong> <strong>AV</strong> enclosure.• This unit uses line fusing which could create an electric shock hazard. Procedures requiring work insidethe <strong>Tracer</strong> <strong>AV</strong> enclosure must be performed by qualified service personnel only.• The supply cord serves as the main power disconnect for the <strong>Tracer</strong> <strong>AV</strong>. The power outlet must beinstalled near the unit and be easily accessible.2.1 Unpacking and AssemblyImmediately after unpacking, visually inspect the <strong>Tracer</strong> <strong>AV</strong> to ensure all components are included andundamaged. The shipping carton should contain the <strong>Tracer</strong> <strong>AV</strong> enclosure, remote display, remote keypad, thismanual, two cables, and a power cord. If any parts were damaged in shipment, notify <strong>Rice</strong> <strong>Lake</strong> <strong>Weighing</strong><strong>Systems</strong> and the shipper immediately.2.2 Enclosure Security/DisassemblyAfter an NTEP inspector has examined the unit, he/she will install security cables pictured in Figure 2-1 andFigure 2-2. These cables prevent the <strong>Tracer</strong> <strong>AV</strong> from being tampered with by an unauthorized individual. If thesecables are removed, NTEP certification will become void.If the <strong>Tracer</strong> <strong>AV</strong> enclosure must be opened by an authorized technician, ensure power is disconnected, then placeit on an anti-static work mat. Cut tamper-proof cables, remove screws, and remove the enclosure’s top cover. AnNTEP inspector will have to examine the unit and attach new security cables.Security cablesFigure 2-1. <strong>Tracer</strong> <strong>AV</strong> (front) security cables installed after NTEP certification.<strong>Tracer</strong> <strong>AV</strong> <strong>Installation</strong> <strong>Manual</strong> - <strong>Installation</strong> 3