Brunner USA Instructions - Robeys Ltd

More documents

Recommendations

Info

Do not blow into the port ofthe pressure measuringline!The pressure compensationopening can be closed.Do not paint over!Do not wall paper over!Before plastering, the flushmountingbox of the USA mustbe removed from the wall box!In order to avoid subsequentdamage to the electronics, theinstallation of the USA must becarefully planned and executed.Figure 3: Pressure equalizationport (X) on top of the USATo do this, note the followingpoints:Tip: Set the flush box withscrewed plastic lid. This willensure distortion-freeinstallation.- Avoid any contact with theelectronic components, as staticelectricity can damage thesecomponents.- Construction moisture damageelectronic components.Brunner USA Installation & Operation Manual 8August 2013
• If possible do not install the USA in an external wall, to avoiddew point corrosion to the electronics.• Do not install the USA in the heated tile cladding.• The mounting shall be such that does not exceed +50 ° C and+10 ° C are not exceeded and the device is not exposed to directheat radiation.• The degree of protection IP 40 is ensured.StructureThe electronics of the USA should (observe permissible ambienttemperatures!) be near the hearth place.An ideal position is slightly above the exhaust sensor port, becauseyou can then ensures that any condensate in the pressure gaugeline runs back to the exhaust gas sensor connection (see alsoFigure: Laying the pressure gauge line).The exhaust gas sensor circuit is to be mounted at a locationwhere the ambient temperature of 180 ° C and the coretemperature of the flue gas does not exceed 500 ° C.This is usually guaranteed in the flue gas at a distance between 70cm and 150 cm from the hearth. Of the pressure measuring pointof the fireplace must not exceed 150 cm. They can be connectedto pipes with diameters from 150 mm to 250 mm.Brunner USA Installation & Operation Manual 9August 2013
Page 1 and 2: INSTALLATION AND OPERATIONBrunner U
Page 3 and 4: The installation of the USA must fo
Page 5 and 6: Brunner USA Installation & Operatio
Page 7: MOUNTING OF THE USAImportant note!T
Page 11 and 12: Connect the pressure gauge lineto t
Page 13 and 14: Ventilation systems, fume hoods, ki
Page 15 and 16: SETTING THE USAThe USA can be a PC
Page 17 and 18: Status indicators:StatusdisplayMean
Page 19 and 20: OPERATIONThe USA offers the possibi
Page 21 and 22: FUNCTION TEST AND MAINTENANCEWhen t
Page 23 and 24: FUSESThe USA has three miniature fu
Page 25 and 26: TECHNICAL DATAThe USA has been test
Page 27 and 28: Brunner USA Installation & Operatio

Brunner USA Instructions - Robeys Ltd

Create successful ePaper yourself

Delete template?

Save as template?