TorqueMaster SD Spring - 9100 9400 9600 - Wayne Dalton

6Tools Needed:LevelBottom SectionBefore installing the bottom section,the weather seal (may not be included)must be installed (see Preparing theOpening on page 10)Center the bottom section in the dooropening. Level section using woodenshims (if necessary) under the bottomsection.weather sealdoor openinglevelBOTTOM SECTIONwooden shims(if necessary)7Vertical Trackcable drumfLAGANGLEvertical trackBOTTOM SECTIONTools Needed:3/16” Drill BitPower Drill7/16” SocketDriverTape MeasureLevelIMPORTANT: The tops of thevertical tracks must be levelfrom side to side. If the bottomsection was shimmed to level it.The vertical track on the shimmedside, must be raised the height ofthe shim.Position the left hand vertical trackassembly over the rollers of the bottomsection. Make sure the counterbalancecable is located between the rollersand the door jamb. Drill 3/16” pilotholes for the lag screws. Loosely fastenjamb brackets and flagangle to thejamb using 5/16” x 1-5/8” lag screws.Tighten lag screw securing bottomjamb bracket to jamb, to maintain5/8” spacing. Hang cable drum overflagangle. Repeat for the right handside.CABLEJAMBBRACKET5/16” x 1-5/8”LAG SCREWSVERTICALTRACKASSEMBLYBOTTOM SECTIONrollerLAGSCREWlocations5/8”12r qi flagangleLAGSCREWlocationsLAGSCREWlocations15r qi flaganglequick installjamb bracket1412r & 15r FullyAdjustable flaganglelagscrewPlease Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com