TorqueMaster SD Spring - 9100 9400 9600 - Wayne Dalton

13Top SectionNAILdoor width+3-3/8” to 3-1/2”Tools Needed:HammerPlace the top section in the openingand vertically align with lower sections.Temporarily secure the top section bydriving a nail in the header near thecenter of the door and bending it over thetop section. Now flip up hinge leaf, holdtight against section, and fasten centerhinges first, and end hinges last. (Referto Step 8). When installing a door with aTorqueMaster ® counterbalance system,vertical track alignment is critical.Position flagangle between 1-11/16” (43mm) to 1-3/4” (44 mm) from the edgeof the door. Flagangles must be parallelto the door sections. Now complete thevertical track installation by securing thecenter jamb bracket and tightening theother lag screws. Repeat for other side.1-11/16”TO 1-3/4”IMPORTANT: The dimension betweenthe flagangles must be doorwidthplus 3-3/8” (86 mm) to 3-1/2”(89 mm) for smooth, safe dooroperation.FLAGANGLEtopSECTION1814Tools Needed:9/16” SocketRatchet Wrench9/16” WrenchLevelAttaching Quick Install Flagangleto Horizontal TrackNOTE: If you have fully adjustable flagangle,skip this step and complete Step 15.To install horizontal track, place the curvedend over the top roller. Align key slot of thehorizontal track with the quick install tabof the flagangle. Push curved portion ofhorizontal track down to lock in place.WARNINGDO NOT RAISE DOOR UNTIL HORIZONTALTRACKS ARE SE CURED AT REAR, ASOUTLINED IN Step 34, OR DOOR COULDFALL FROM OVERHEAD POSI TION CAUSINGSEVERE OR FATAL INJURY.Level the horizontal track assembly andbolt the horizontal angle to the slot in theflagangle using (1) 3/8” - 16 x 3/4” trusshead bolt and (1) 3/8” - 16 hex nut. Repeatfor other side. Remove the nail that wastemporarily holding the top section in place,installed in Step 13.IMPORTANT: Failure to remove nailbefore attempting to raise doorcould cause permanent damage totop section.NOTE: If an idrive ® opener will be installed,position horizontal tracks slightly above level.NOTE: After completing this step, continuewith Step 16.horizontaltrackQUICKINSTALLTABverticaltrackPlease Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.comkeyslot3/8” - 16 X 3/4”TRUSS HEAD BOLTflaganglehorizontaltrackkey slotverticaltrackQUICKINSTALLTAB3/8” - 16 Hex nutHORIZONTAL TRACKflaganglehorizontal ANGLE