TorqueMaster SD Spring - 9100 9400 9600 - Wayne Dalton

19Tools Needed:idrive ® InstallationNOTE: See idrive ® main installation andowners manual for idrive ® parts.IMPORTANT: Right and left handis always determined from insidethe garage looking out.With the TorqueMaster ® spring tube onthe floor (inside garage) in front of thedoor with the labeled end to the left.Look into the opener’s left side toensure the left hand bearing and theinternal (black) sleeve are aligned withthe TorqueMaster ® spring tube profile.Left Hand SideTorqueMaster ® Spring Tubeand Bearing profiles alignedRight Hand Endof TorqueMaster ®Spring TubeMotorIMPORTANT: Hold Opener by themain body. Do NOT hold by theMotor.NOTE: Opener will not slide over atorque tube label. Attempting to slideopener over the left end of theTorqueMaster ® spring tube can damagethe internal electronics.Once aligned, slide the opener onto theright hand end of the TorqueMaster ®spring tube. As the right end of theTorqueMaster ® spring tube enters theinternal (black) sleeve, rotate theopener back and forth slightly to helpaid alignment.Continue sliding the opener onto theTorqueMaster ® spring tube. Align theright hand bearing with theTorqueMaster ® spring tube and slidethe opener completely onto theTorqueMaster ® spring tube until theTorqueMaster ® spring tube exits theopener right hand bearing.Right Hand SideTorqueMaster ®Spring Tube andBearing profilesalignedINSTALLATIONNOTE: Do not force the opener onto theTorqueMaster ® spring tube ifmisalignment occurs.Continue sliding the opener to thecenter of the TorqueMaster ® springtube.Plug the motor power cord into theopener.Plug-in MotorPower CordPlease Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com21