TorqueMaster SD Spring - 9100 9400 9600 - Wayne Dalton

❉Side Lock1/8”Tools Needed:Power Drill7/16” SocketDriverInstall the side lock on the secondsection of the door. Secure the lock tothe section with (4) 1/4”- 20 x 11/16”self drilling screws. Square the lockassembly with the door section andalign with the square hole in the verticaltrack. The side lock should be spacedapproximately 1/8” from the sectionedge.IMPORTANT: side locks must beremoved or made inoperative inthe unlocked position if anoperator is installed on the door.NOTE: After completing this step,continue with Step 9 on page 15.(4) 1/4”- 20 x 11/16”self drilling screws❉Tools Needed:NoneDoorMaster TM BracketANOTE: When installing a DoorMaster TMoperator use the center bracket anddrive gear supplied with your operator(located in DoorMaster TM package).aDoorMaster TM bracket/DRIVE GEAR ASSEMBLYSlide the DoorMaster TM bracket/drivegear assembly onto the TorqueMaster ®spring tube, so that the drive gear/centerbracket assembly are in the center ofthe TorqueMaster ® spring tube.NOTE: After completing this step,continue with Step 20 on page 22.Torquemaster ® tubeTools Needed:Power Drill1/8” Drill Bit7/16” SocketDriverBTo locate the center bracket, mark theheader halfway between the flaganglesand level the TorqueMaster ® spring tube.Drill 1/8” pilot holes into header for thelag screws. Fasten the metal bracket tothe header using (2) 1/4” x 1-1/2” lagscrews.bCENTERBRACKETbushingASSEMBLY32NOTE: After completing this step,continue with Step 29 on page 28.(2) 1/4” x 1-1/2”hex head lagscrewsPlease Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to yourlocal yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com